Skip to contentSkip to conversation

"hda-intel: azx_get_response timeout"

DISCUSSION Mantas M. 2 participants 2 messages Dec 16, 2012 – Dec 17, 2012

lore
Share & tools
lore

Mantas M.

author
#0 lore raw

After upgrading to Linux 3.7 (on Arch Linux, x86_64), I've been getting the following messages in dmesg:

Quoted 3 lines

[Dec11 21:52] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x001f0500 [ +1.006709] hda-intel: No response from codec, disabling MSI: last cmd=0x001f0500 [ +1.006773] hda_intel: azx_get_response timeout, switching to single_cmd mode: last cmd=0x001f0500

This seems to happen when resuming from suspend-to-memory, and is new to v3.7 – I haven't seen any such messages on any kernels I've used earlier (between v3.0 and v3.6.9).

The device is:

Quoted 11 lines
# lspci -v
00:1b.0 Audio device: Intel Corporation 5 Series/3400 Series Chipset High Definition Audio (rev 06)
	Subsystem: ASUSTeK Computer Inc. Device 1643
	Flags: bus master, fast devsel, latency 0, IRQ 22
	Memory at d5200000 (64-bit, non-prefetchable) [size=16K]
	Capabilities: [50] Power Management version 2
	Capabilities: [60] MSI: Enable- Count=1/1 Maskable- 64bit+
	Capabilities: [70] Express Root Complex Integrated Endpoint, MSI 00
	Capabilities: [100] Virtual Channel
	Capabilities: [130] Root Complex Link
	Kernel driver in use: snd_hda_intel

Is there anything I can/should do about this?

Signature · 6 lines
Mantas Mikulėnas <[email protected]>

_______________________________________________
Alsa-devel mailing list
[email protected]
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel
#1 lore raw

At Sun, 16 Dec 2012 18:04:17 +0200,

Quoted 26 lines · Mantas M.

After upgrading to Linux 3.7 (on Arch Linux, x86_64), I've been getting the following messages in dmesg:

Quoted 3 lines

[Dec11 21:52] hda-intel: azx_get_response timeout, switching to polling mode: last cmd=0x001f0500 [ +1.006709] hda-intel: No response from codec, disabling MSI: last cmd=0x001f0500 [ +1.006773] hda_intel: azx_get_response timeout, switching to single_cmd mode: last cmd=0x001f0500

This seems to happen when resuming from suspend-to-memory, and is new to v3.7 – I haven't seen any such messages on any kernels I've used earlier (between v3.0 and v3.6.9).

The device is:

Quoted 11 lines
# lspci -v
00:1b.0 Audio device: Intel Corporation 5 Series/3400 Series Chipset High Definition Audio (rev 06)
	Subsystem: ASUSTeK Computer Inc. Device 1643
	Flags: bus master, fast devsel, latency 0, IRQ 22
	Memory at d5200000 (64-bit, non-prefetchable) [size=16K]
	Capabilities: [50] Power Management version 2
	Capabilities: [60] MSI: Enable- Count=1/1 Maskable- 64bit+
	Capabilities: [70] Express Root Complex Integrated Endpoint, MSI 00
	Capabilities: [100] Virtual Channel
	Capabilities: [130] Root Complex Link
	Kernel driver in use: snd_hda_intel
Quoted 1 line

Is there anything I can/should do about this?

It might be the runtime PM things.
Try to give power_save_controller=0 option to snd-hda-intel module.

Takashi
_______________________________________________
Alsa-devel mailing list
[email protected]
http://mailman.alsa-project.org/mailman/listinfo/alsa-devel