Skip to contentSkip to conversation

U-Boot hang on icache enable

U-Boot-Users Siju Viswanath 2 participants 3 messages Feb 23, 2006

lore
Share & tools
lore
#0 lore raw

Hi,
I have a MPC8247 board with 2MB flash and 64MB SDRAM.
I am using u-boot 1.1.2. The u-boot comes up if I disable the icache. But when I enable instruction cache from config file (HID0_ICE set in CFG_HID0_FINAL) it hangs in cpu/mpc8260/start.S code shown below. Any pointers as to what could be the issue would be helpful.

in_ram:

	/*
	 * Relocation Function, r14 point to got2+0x8000
	 *
	 * Adjust got2 pointers, no need to check for 0, this code
	 * already puts a few entries in the table.
	 */
	li	r0,__got2_entries at sectoff@l
	la	r3,GOT(_GOT2_TABLE_)
	lwz	r11,GOT(_GOT2_TABLE_)
	mtctr	r0
	sub	r11,r3,r11
	addi	r3,r3,-4
1:	lwzu	r0,4(r3)
	add	r0,r0,r11
	stw	r0,0(r3)
	bdnz	1b

thanks,
Siju Viswanath
Tejas Networks

#1 lore raw
Quoted 7 lines · In message <[email protected]> you wrote:

Hi,
I have a MPC8247 board with 2MB flash and 64MB SDRAM.
I am using u-boot 1.1.2. The u-boot comes up if I disable the icache. But when I enable instruction cache from config file (HID0_ICE set in CFG_HID0_FINAL) it hangs in cpu/mpc8260/start.S code shown below. Any pointers as to what could be the issue would be helpful.

http://www.denx.de/wiki/view/DULG/UBootCrashAfterRelocation

Best regards,

Wolfgang Denk

Signature · 4 lines
Software Engineering:  Embedded and Realtime Systems,  Embedded Linux
Phone: (+49)-8142-66989-10 Fax: (+49)-8142-66989-80 Email: wd at denx.de
I've already got a female to worry about. Her name is the Enterprise.
	-- Kirk, "The Corbomite Maneuver", stardate 1514.0