Skip to contentSkip to conversation

Need inforamtion on execve(2) on ENOMEM

DISCUSSION Halesh S 2 participants 2 messages Aug 1, 2008

lore
Share & tools
lore

Halesh S

author
#0 lore raw

Hi,

I need a bit information regarding execve(2) sys call failure on no memory.

when execve(2) exits with ENOMEM, it will fail to return back to the calling program as it receives the SIGKILL from the kernel.

Is it a right behavior that execve() will not return to calling program on ENOMEM. As I understood execve(2) will not return only on success.

As errno will be lost, its very diffcult to judge execve(2) status.

If not expected behaviour, I can provide a testcase for this.

Please let me about this.

Thanks,
Halesh

#1 lore raw
Quoted 7 lines · Halesh S

Hi,

I need a bit information regarding execve(2) sys call failure on no memory.

when execve(2) exits with ENOMEM, it will fail to return back to the calling program as it receives the SIGKILL from the kernel.

Quoted 8 lines

Is it a right behavior that execve() will not return to calling program on ENOMEM. As I understood execve(2) will not return only on success.

As errno will be lost, its very diffcult to judge execve(2) status.

If not expected behaviour, I can provide a testcase for this.

Please let me about this.

It only does the SIGKILL bit when it runs out of memory after the old programm is dead and the new programm isn't quite running yet.

So there is no calling programm to return to.