Skip to contentSkip to conversation

What is meant by chained interrupt handlers, when to use them.

DISCUSSION Valmiki 1 participant 2 messages Dec 20, 2015 – Dec 21, 2015 PCI

lore
Share & tools
lore

Valmiki

author
#0 lore raw

I'm seeing that chained_irq_enter/exit functions are being used in cained irq handlers.

These chained_irq_enter/exit functions are doing ack, mask, unmask functions from irq chip.
Already when an interrupt handler is being executed that IRQ line will be disabled by linux, so what is the purpose of masking/unmasking them.

What is term chained referring to, does it mean reading interrupt status register and check for bit set one after and another handle that corresponding IRQ, so in a chain fashion.

Valmiki

author
#1 lore raw
Quoted 2 lines · Valmiki <valmikibow <at> gmail.com> writes:

I'm seeing that chained_irq_enter/exit functions are being used in

cained

Quoted 5 lines

irq handlers.

These chained_irq_enter/exit functions are doing ack, mask, unmask functions from irq chip.
Already when an interrupt handler is being executed that IRQ line will

be

Quoted 3 lines

disabled by linux, so what is the purpose of masking/unmasking them.

What is term chained referring to, does it mean reading interrupt

status

Quoted 2 lines

register and check for bit set one after and another handle that corresponding IRQ, so in a chain fashion.

When we use irq_set_chained_handler the irq line will not be disabled, unlike request_irq ?
If that is the case calling chained_irq_enter which does mask/unmask to only current irq line, but i see in some pcie root port drivers after calling this they are handling all the available interrupts but only one is masked ? Is this method correct ?

Quoted 4 lines

Valmiki