Skip to contentSkip to conversation

2.4.20-PATCH: serial.c - allow debug compile

PATCH Pavel Janík 1 participant 1 message Dec 10, 2002 Char and misc drivers

lore
Share & tools
lore

Pavel Janík

author
#0 lore raw

Hi,

this patch allows compilation of serial device driver with debugging turned on, please apply.

drivers/char/serial.c +2 -2
@@ -914,7 +914,7 @@
 		    ((iir & UART_IIR_ID) == UART_IIR_THRI))
 			transmit_chars(info, 0);
 		if (pass_counter++ > RS_ISR_PASS_LIMIT) {
-#if SERIAL_DEBUG_INTR
+#ifdef SERIAL_DEBUG_INTR
 			printk("rs_single loop break.\n");
 #endif
 			break;

@@ -4181,7 +4181,7 @@
    
 #ifdef SERIAL_DEBUG_PCI
 	printk(KERN_DEBUG " Subsystem ID %lx (intel 960)\n",
-	       (unsigned long) board->subdevice);
+	       (unsigned long) dev->subsystem_device);
 #endif
 	/* is firmware started? */
 	pci_read_config_dword(dev, 0x44, (void*) &oldval);
Signature · 4 lines
Pavel Janík

Doctor, it hurts, where is my problem?
                  -- Hubert Mantel with his crystal-ball