Skip to contentSkip to conversation

Seagate IDE tape problems

DISCUSSION Pete Zaitcev 2 participants 2 messages Feb 22, 2002 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive
Quoted 9 lines

I'm having trouble with a Seagate IDE tape drive that previously worked with 2.2.x kernels. (tape is a STT8000A travan drive) [...]
PIIX4: not 100% native mode: will probe irqs later

    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA

hda: SAMSUNG SV2042H, ATA DISK drive
hdc: SAMSUNG SV3063H, ATA DISK drive
hdd: Seagate STT8000A, ATAPI TAPE drive

Make sure you switched DMA off with hdparm -d0. You must find corresponding /dev/hdX, hdparm does not work on /dev/ht0. If is a known problem (Red Hat bug #54517).

BTW, if you have trouble with Red Hat kernels, you may find better luck trying Red Hat support. What if I did not see your message here?

-- Pete

#2 lore raw
In reply to a message not in the archive
Quoted 11 lines · Pete Zaitcev
Quoted 10 lines

I'm having trouble with a Seagate IDE tape drive that previously worked with 2.2.x kernels. (tape is a STT8000A travan drive) [...]
PIIX4: not 100% native mode: will probe irqs later

    ide0: BM-DMA at 0xf000-0xf007, BIOS settings: hda:DMA, hdb:pio
    ide1: BM-DMA at 0xf008-0xf00f, BIOS settings: hdc:DMA, hdd:DMA

hda: SAMSUNG SV2042H, ATA DISK drive
hdc: SAMSUNG SV3063H, ATA DISK drive
hdd: Seagate STT8000A, ATAPI TAPE drive

Quoted 7 lines

Make sure you switched DMA off with hdparm -d0. You must find corresponding /dev/hdX, hdparm does not work on /dev/ht0. If is a known problem (Red Hat bug #54517).

BTW, if you have trouble with Red Hat kernels, you may find better luck trying Red Hat support. What if I did not see your message here?

Because it was related to ide-tape (which I don't use) and it also was about the tape not working at all or with massive amounts of errors. Which I already know, bacause I tried it.
I now run with the SCSI emulation (scsi_mod, ide-scsi etc) and it seems to *almost* work fine...

I'll try with DMA off and see what happens, but that should slow down the other HDD on the bus, right?

Is there any known problems with changing the DMA settings back and forth on a live production system?

/magnus

Quoted 2 lines

-- Pete