83xx: UEC: Added support for bitBang MII driver access to PHYs
PATCH 1/1 83xx: UEC: Added support for bitBang MII driver access to PHYs
This patch enabled support for having PHYs on bitBang MII and uec MII operating at the same time. Modeled after the MPC8360ADS implementation.
Added the ability to specify which ethernet interfaces have bitbang SMI on the board header file.
---
Hi Ben,
Just wanted to follow up, I posted replies to your feedback for V1 of this patch, but did not hear from you about it. Now that the merge window is open again, I thought I should try again. So here is V2 with the changes you suggested.
Thanks
drivers/qe/uec.c | 6 ++---- drivers/qe/uec_phy.c | 47 +++++++++++++++++++++++++++++++++++++++++++++++ 2 files changed, 49 insertions(+), 4 deletions(-)
drivers/qe/uec.c +2 -4
@@ -595,8 +595,7 @@ static void phy_change(struct eth_device *dev)adjust_link (dev); } -#if defined(CONFIG_MII ) || defined(CONFIG_CMD_MII ) \ - && !defined(BITBANGMII ) +#if defined(CONFIG_MII ) || defined(CONFIG_CMD_MII )/* * Find a device index from the devlist by name
@@ -1388,8 +1387,7 @@ int uec_initialize(bd_t *bis, uec_info_t *uec_info)return err; } -#if defined(CONFIG_MII ) || defined(CONFIG_CMD_MII ) \ - && !defined(BITBANGMII ) +#if defined(CONFIG_MII ) || defined(CONFIG_CMD_MII )miiphy_register (dev->name, uec_miiphy_read, uec_miiphy_write);#endif
drivers/qe/uec_phy.c +47 -0
65 lines not on this page · raw message
Signature · 1 line
1.7.0