Skip to contentSkip to conversation

Add Kernel Configuration Fragment

Buildroot Andreas Ziegler 1 participant 1 message Sep 29, 2024 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw

Hi Andy,

Quoted 10 lines · Andrew McCann

I want to add the following line to my linux .config file found in output/build/linux-custom/.config:
CONFIG_KERNEL_ALL_ADI_DRIVERS=y

I put this line in the file located at board/andrew/rpi/linux_frag.conf and referenced it in the buildroot menuconfig as shown below. However, after running make, the .config file is not updated with this line.

Is there a different menuconfig option I should be using to accomplish this?

The location is the correct one.

(1) There is a 'make' rule behind this, so if the .config is newer than the fragment file, the merge never happens.
(2) Check if you can see the symbol in the kernel config menu (run make linux-nconfig, search with F8). You can only use symbols that kconfig knows about.

Kind regards,
Andreas

Quoted 2 lines

Regards
Andy

_______________________________________________
buildroot mailing list
[email protected]
https://lists.buildroot.org/mailman/listinfo/buildroot