Skip to contentSkip to conversation

Using at91 with a different parallel flash, request for help

U-Boot-Users Roman Kolesnikov 1 participant 1 message Jun 10, 2006 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive

Hello,
The only difference I see is in the CFI address 13h becomes 3 for my chip instead of 2 for at91rm9200ek board parallel flash. I am not sure what altogether must be changed. As always with me, the experience always comes after the need.

Thanks
Roman

Message: 8
Date: Fri, 09 Jun 2006 20:18:25 -0700
From: Roman Kolesnikov <[email protected]>
Subject: [U-Boot-Users] Using at91 with a different parallel flash
request for help
To: u-boot-users at lists.sourceforge.net
Message-ID: <[email protected]>
Content-Type: text/plain; charset=ISO-8859-1; format=flowed

Hello,
I am using a similar to at91rm9200ek board. The board is very similar to that of at91rm9200ek, except that the framebuffer is off and few other minor changes.

I am also using an atmel parallel flash. It is 8 MB = 4M x16 by Atmel at49bv6416c. When I boot u boot 1.1.4 my sdram shows up (all 32MB) but my bank 1 shows 0.

I am reading the board setup files and flash.c, but I am not shure what specifically to look for.

Please advice,
Roman