Skip to contentSkip to conversation

idetape broke in 2.4.x-2.4.9-ac5 (write OK but not read) ide-scsi works in 2.4.4

DISCUSSION Pete Zaitcev 1 participant 1 message Sep 4, 2001 1 message not in the archive

lore
Share & tools
lore

A message that is not in the archive (sent off-list or not yet received): [email protected]

#1 lore raw
Quoted 9 lines
Quoted 5 lines

Kernel 2.4.9-ac5 on i686
then
ide-tape: ht0: I/O error, pc = 8, key = 5, asc = 2c, ascq = 0
tar: /dev/ht0: Cannot read: Input/output error
(writes work OK though)

- block size: The 2.4 ide-tape driver only works reliably if you write data with the correct block size. If you don't write full blocks the last block of data may not be readable.

I fixed that some time ago, it's in current -ac if not in Linus's tree. The bug has nothing to do with the ASC=2c problem the original poster complained.

Quoted 2 lines

- HP's not-quite ATAPI drives: Don't know about your model, but the HP 14(?)GB model is believed to deviate from ATAPI standards.

Colorado sucks... I think I have a bug pending about it, did not look well yet. IIRC it was giving ASC=24, not 2c. I'll look it up.

-- Pete