Skip to contentSkip to conversation

building linux router with QoS what about performance

LARTC Thomas Kirk 1 participant 1 message Oct 1, 2001

lore
Share & tools
lore
#0 lore raw

Hey Listmembers

Im currently looking into building a linuxrouter which has one purpose. To divide bandwidth to networks. The setup will look like this :

Cisco 7120/oc3/100mbit--eth0--eth1,2,3,4 etc etc

Im planning to use CBQ to divide bandwidth against the diffrent network. Right now im trying to figure out what the hardware requirments would be and how scaleable this solution will be? Have anyone on this list tried to doing something equal this setup or have experince with QoS on high bandwidth links?

Thanks in advance

Signature · 15 lines
Venlig hilsen/Kind regards
Thomas Kirk
ARKENA
[email protected]
Http://www.arkena.com


"[In 'Doctor' mode], I spent a good ten minutes telling Emacs what I
thought of it.  (The response was, 'Perhaps you could try to be less
abusive.')"
(By Matt Welsh)

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/