Skip to contentSkip to conversation

LARTC digest, Vol 1 #385 - 12 msgs

LARTC Sanjeev Lakshmanan 2 participants 2 messages Dec 21, 2001

lore
Share & tools
lore
#0 lore raw

Hello all,

I need to setup point to point routes between 5 computers running Redhat Linux 7.1

Our project requires that we have the same IP address for each ethernet card. We have 4 ethernet cards on each system.

1.Please let me know how I should assign the IP addresses to each card without conflict.
2. Do I also need to have broadcast addresses configured for each interface?
3. How can I setup the routes between the point to point links(I need to create routes based on the cabling)
4.Do I need to connect all the 5 systems to a switch?

The systems are connected by crossover ethernet cables amongst themselves. There is NO OTHER device in the network.

I tried to create routes by doing the following:

1. If eth0 on sys 1 is connceted to eth 1 on sys 2, then on sys 1 i entered,
root#ip neigh add 192.168.2.y lladdr as:sf:dg:fh:gj:gk dev eth1 nud perm
root#ip route add 192.168.2.y scope link src 192.168.1.z

Then I did the similar config on sys 2 also .

But when I tried to ping one from the other, it gives message "destination host unreachable"

Please let me know how I can get around this.

And once I get these static routes configured, If i run gated or zebra, wil these rutes be deleted and replaced by the new routing tables? Or can we configure zebra, gated to get updates on these already existing routes?

Also please let me know if I can configure zebra ospf to work with my network(with each ethernet card on a system having the SAME Ip address)

Please let me know if you need more information to answer any of my questions.

Regards,
Sanjeev.

__________________________________________________
Do You Yahoo!?
Check out Yahoo! Shopping and Yahoo! Auctions for all of your unique holiday gifts! Buy at http://shopping.yahoo.com
or bid at http://auctions.yahoo.com

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/

#1 lore raw
Quoted 8 lines · Sanjeev Lakshmanan

Hello all,

I need to setup point to point routes between 5
computers running Redhat Linux 7.1

Our project requires that we have the same IP address for each ethernet card. We have 4 ethernet cards on each system.

Look at the linux virtualserver project - they have similar needs.

Regards,

bert

Signature · 8 lines
http://www.PowerDNS.com          Versatile DNS Software & Services
http://www.tk                              the dot in .tk
Netherlabs BV / Rent-a-Nerd.nl           - Nerd Available -
Linux Advanced Routing & Traffic Control: http://ds9a.nl/lartc

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/