Skip to contentSkip to conversation

Ip addr, zebra

LARTC Sanjeev Lakshmanan 2 participants 2 messages Dec 23, 2001

lore
Share & tools
lore
#0 lore raw

Hi,

Could anyone help me with these doubts:

1. When i delete the ip address for each interface and assign a new one,(first ip addr del ... and then ip addr add ...) , after i reboot the system, the old delted ip address is appearing on the interfaces. What could be the problem. I am using Redhat linux 7.1

2. If i need to setup 3 interconnceted systems for routing, then do i need to run the zebra daemon on each of the 3 machines by placing their respective zebra.conf files in usr/local/etc?

3. Before running zebra, do i need to assign the ip addresses to the interfaces or does the zebra.conf file take care of it?

4. Is a switch/hub required to run zebra or will the daemon run even when i just have point to point ethernet cables between systems?

Thank you,

Regards,
Sanjeev.

__________________________________________________
Do You Yahoo!?
Send your FREE holiday greetings online!
http://greetings.yahoo.com

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/

#1 lore raw
Quoted 5 lines · Sanjeev Lakshmanan

1. When i delete the ip address for each interface and assign a new one,(first ip addr del ... and then ip addr add ...) , after i reboot the system, the old delted ip address is appearing on the interfaces. What could be the problem. I am using Redhat linux 7.1

Read your Redhat manual. Redhat stores the boot-up addresses in a series of files under /etc/sysconfig/network-scripts. Changing the address 'live' with ip or ifconfig will not change the boot-up address of the machine.

Quoted 4 lines

2. If i need to setup 3 interconnceted systems for routing, then do i need to run the zebra daemon on each of the 3 machines by placing their respective zebra.conf files in usr/local/etc?

You can usually just add the appropriate static routes to each system's routing table. If you feel dynamic routing is necessary, decide which protocol (usually OSPF in this situation) you need, and configure it according to the docs.

If the three machines are just part of one IP network then just assign their addresses, connect them to each other, and watch the packets fly ... ;-) A few more details about your exact setup would help of course.

Quoted 3 lines

4. Is a switch/hub required to run zebra or will the daemon run even when i just have point to point ethernet cables between systems?

If you have three systems with point to point connections, see above; you probably don't need dynamic routing software like Zebra at all.

Signature · 7 lines
Michael T. Babcock
CTO, FibreSpeed Ltd.     (Hosting, Security, Consultation, Database, etc)
http://www.fibrespeed.net/~mbabcock/

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/