Am I on the right Track?
Hi there,
Is it possible to somehow have a fairly basic routing level in order to forward packets from eth1 to eth0? Simply using "route"?
I have a Cisco that has a local network IP. It is on eth0 interface. I have a Switch on eth1. I want to supply eth1 with a Real World IP which comes through the Cisco.
Any guidance available?
I assigned 10.0.0.2 on eth0 and 210.54.149.189 on eth1.
then I did this:
route add -net 10.0.0.0 netmask 255.255.255.0 gw 10.0.0.1 dev eth0 route add -net 210.54.149.160 netmask 255.255.255.224 gw 10.0.0.1 (which says network unreachable)
Could someone please tell me how I could solve this?
Regards,
Sahil Gupta
NET4U Limited
------------------------------------
NET4U -- www.net4u.co.nz
Home of the new - $24.95 128k ADSL
Nationwide Internet Service Provider
------------------------------------
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/
Sahil,
I'm assuming your network looks like this (appologies for bad ascii graphics):
10.0.0.0/24 210.54.149.160/27
NET---[cisco]---------------[linux box]-----LAN/DMZ
Is that correct?
If so, your cisco needs to route 210.54.149.160/27 via 10.0.0.2 (eth0 on the linux box), and your Linux box needs a default route via 10.0.0.1 so traffic goes out via the cisco (if that is your default route!)
And that's it. There is no reason to add a route to the 210.54.149.160/27 range on the Linux box because it is directly connected to eth1.
Quoted 32 lines
-----Original Message-----
From: Sahil Gupta - NET4U [mailto:[email protected]]
Sent: Tuesday, January 15, 2002 12:39 PM
To: [email protected]
Subject: [LARTC] Am I on the right Track?Hi there,
Is it possible to somehow have a fairly basic routing level in order to forward packets from eth1 to eth0? Simply using "route"?I have a Cisco that has a local network IP. It is on eth0 interface. I have a Switch on eth1. I want to supply eth1 with a Real World IP which comes through the Cisco.
Any guidance available?
I assigned 10.0.0.2 on eth0 and 210.54.149.189 on eth1. then I did this:
route add -net 10.0.0.0 netmask 255.255.255.0 gw 10.0.0.1 dev eth0 route add -net 210.54.149.160 netmask 255.255.255.224 gw 10.0.0.1 (which says network unreachable)Could someone please tell me how I could solve this?
Regards,
Sahil Gupta
NET4U Limited------------------------------------
NET4U -- www.net4u.co.nz
Quoted 9 lines
Home of the new - $24.95 128k ADSL
Nationwide Internet Service Provider
------------------------------------_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc > HOWTO:
http://ds9a.nl/lartc/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/