Skip to contentSkip to conversation

A basic setup question

LARTC Ali badilli 3 participants 3 messages Jan 19, 2002 – Jan 20, 2002

lore
Share & tools
lore
#0 lore raw

Hi,

I have just started to build a small linux network. I have the following question. If anybody helps I will be really appreciated.

I have installed linux 7.2 in machine A, B, C and connected them as follows.

A-----------C----------B
eth0 eth0 eth1 eth0

As it is shown in figure C has two ethernet interfaces eth0 connected to A and eth1 connected to B.

I have assigned the addresses as follows:

A: 192.20.1.3 (eth0) mask:255.255.255.0 default gw:192.20.1.1

B: 192.20.2.3 (eth0) mask:255.255.255.0 default gw:192.20.2.1

C: 192.20.1.1 (eth0) mask:255.255.255.0

                     default gw:192.20.2.1

and 192.20.2.1 (eth1) mask:255.255.255.0

                      default gw:192.20.1.1 

C acts as gateway between between A and B.

I configure routing table as follows:

A: destination network network mask gateway
0.0.0.0 0.0.0.0 92.20.1.1

192.20.1.0 255.255.255.0 192.20.1.3

B:destination network network mask gateway
0.0.0.0 0.0.0.0 92.20.2.1

192.20.2.0 255.255.255.0 192.20.2.3

C:destination network network mask gateway
192.20.2.0 255.255.255.0 192.20.2.1
(eth0)
192.20.1.0 255.255.255.0 192.20.1.1
(eth1)

I can ping from A to 192.20.2.1 but I cannot ping to 192.20.2.3(which is B)

similarly,

I can ping from B to 192.20.1.1 but cannot ping to 192.20.1.3 (which is A).

In other word, Both A and B can ping the interfaces of C which belong to different subnets, but A and B cannot ping each other.

Am I missing some basic configuration things?, Should I install any other patch or etc?,

I will be really appreciated If some body give me clear explanation. Sorry for asking a simple question.

Haci

__________________________________________________
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail!
http://promo.yahoo.com/videomail/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/

#1 lore raw

Make sure you are doing this on machine C:

echo "Turning on IP forwarding"
echo "1" > /proc/sys/net/ipv4/ip_forward

That turns on the routing code on machine C.

- Greg Scott

-----Original Message-----
From: Ali badilli [mailto:[email protected]]
Sent: Saturday, January 19, 2002 4:50 PM
To: [email protected]
Subject: [LARTC] A basic setup question

Hi,

I have just started to build a small linux network. I have the following question. If anybody helps I will be really appreciated.

I have installed linux 7.2 in machine A, B, C and connected them as follows.

A-----------C----------B
eth0 eth0 eth1 eth0

As it is shown in figure C has two ethernet interfaces eth0 connected to A and eth1 connected to B.

I have assigned the addresses as follows:

A: 192.20.1.3 (eth0) mask:255.255.255.0 default gw:192.20.1.1

B: 192.20.2.3 (eth0) mask:255.255.255.0 default gw:192.20.2.1

C: 192.20.1.1 (eth0) mask:255.255.255.0

                     default gw:192.20.2.1

and 192.20.2.1 (eth1) mask:255.255.255.0

                      default gw:192.20.1.1 

C acts as gateway between between A and B.

I configure routing table as follows:

A: destination network network mask gateway
0.0.0.0 0.0.0.0 92.20.1.1

192.20.1.0 255.255.255.0 192.20.1.3

B:destination network network mask gateway
0.0.0.0 0.0.0.0 92.20.2.1

192.20.2.0 255.255.255.0 192.20.2.3

C:destination network network mask gateway
192.20.2.0 255.255.255.0 192.20.2.1
(eth0)
192.20.1.0 255.255.255.0 192.20.1.1
(eth1)

I can ping from A to 192.20.2.1 but I cannot ping to 192.20.2.3(which is B)

similarly,

I can ping from B to 192.20.1.1 but cannot ping to 192.20.1.3 (which is A).

In other word, Both A and B can ping the interfaces of C which belong to different subnets, but A and B cannot ping each other.

Am I missing some basic configuration things?, Should I install any other patch or etc?,

I will be really appreciated If some body give me clear explanation. Sorry for asking a simple question.

Haci

__________________________________________________
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail!
http://promo.yahoo.com/videomail/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/

#2 lore raw
In reply to Ali badilli

Did you enaled ip-forwarding on machine C ?
echo "1" > /proc/sys/net/ipv4/ip_forward

Stef

Quoted 115 lines · Ali badilli

Hi,

I have just started to build a small linux network. I have the following question. If anybody helps I will be really appreciated.

I have installed linux 7.2 in machine A, B, C and connected them as follows.

A-----------C----------B
eth0 eth0 eth1 eth0

As it is shown in figure C has two ethernet interfaces eth0 connected to A and eth1 connected to B.

I have assigned the addresses as follows:

A: 192.20.1.3 (eth0) mask:255.255.255.0 default gw:192.20.1.1

B: 192.20.2.3 (eth0) mask:255.255.255.0 default gw:192.20.2.1

C: 192.20.1.1 (eth0) mask:255.255.255.0

                     default gw:192.20.2.1

and 192.20.2.1 (eth1) mask:255.255.255.0

                      default gw:192.20.1.1

C acts as gateway between between A and B.

I configure routing table as follows:

A: destination network network mask gateway
0.0.0.0 0.0.0.0 92.20.1.1

192.20.1.0 255.255.255.0 192.20.1.3

B:destination network network mask gateway
0.0.0.0 0.0.0.0 92.20.2.1

192.20.2.0 255.255.255.0 192.20.2.3

C:destination network network mask gateway
192.20.2.0 255.255.255.0 192.20.2.1
(eth0)
192.20.1.0 255.255.255.0 192.20.1.1
(eth1)

I can ping from A to 192.20.2.1 but I cannot ping to 192.20.2.3(which is B)

similarly,

I can ping from B to 192.20.1.1 but cannot ping to 192.20.1.3 (which is A).

In other word, Both A and B can ping the interfaces of C which belong to different subnets, but A and B cannot ping each other.

Am I missing some basic configuration things?, Should I install any other patch or etc?,

I will be really appreciated If some body give me clear explanation. Sorry for asking a simple question.

Haci

__________________________________________________
Do You Yahoo!?
Send FREE video emails in Yahoo! Mail!
http://promo.yahoo.com/videomail/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/

Signature · 7 lines
[email protected]
 More QOS info : http://www.docum.org/
 Title : "Using Linux as bandwidth manager"
     
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/lartc/