Basic Question on TBF
Hi alll..
This is Very basic question on TBF.
The rate specified for Token bucket filter is to
throttle the extra packets...
For example...
If my Etho interface receives 5mb of traffic
and if i have this following command...
tc qdisc add dev eth0 root tbf 1mbit burst 10k latency 350ms
Does this mean that remaining 4 mb will be
dropped..???
But this is not happening all the 5mb is reaching the Destination..
Any suggestions are appreciated.
Thanks
RR
__________________________________________________
Do You Yahoo!?
Try FREE Yahoo! Mail - the world's greatest free email!
http://mail.yahoo.com/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 10 lines · Rajesh Revuru
Hi alll..
This is Very basic question on TBF.
The rate specified for Token bucket filter is to
throttle the extra packets...For example...
If my Etho interface receives 5mb of traffic
and if i have this following command...
This means you want to incoming bandwith.
Quoted 2 lines
tc qdisc add dev eth0 root tbf 1mbit burst 10k latency 350ms
This will limit the outgoing bandwith to 1mbit.
Quoted 4 lines
Does this mean that remaining 4 mb will be dropped..???
But this is not happening all the 5mb is reaching the Destination..
And now you want to limit the bandwith you send ?
Do you want to shape the incoming or the outgoing packets? You can only shape packets you send to somewhere else.
Stef
Signature · 7 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.openprojects.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/