Question on Linux Traffic Management
Hi,
I have been playing with the Linux advanced traffic management and have a few questions. I have been working with a Pentium based PC with two ethernet ports. Traffic received on the first port is sent to the second port, on which CBQ is configured. I am using the Redhat 7.2 distribution with Kernel 2.4.7
1. If I create a bounded, isolated class (1:1) below the root qdisc (1:0) and set its rate (i.e. for class 1:1) to 50Mbits/sec, the actual traffic rate observed is significantly different from the configured value. Measurements were made over an interval of 15 sec to 1 minute. The bandwidth parameter of the root qdisc was set to 100Mbit/sec. Why is this happening and has anyone else encountered this behaviour?
2. The Linux Advanced Routing & Traffic Control HOWTO says that one cannot shape a flow above 1Mbit/sec accurately because the scheduling tick is 10 millisec. Is there a way to get around this to accurately shape higher rate flows?
3. Is anyone working on any other hierarchical queuing disciplines beyond CBQ and HTB? If so where can I find out more about this?
Thanks,
- Udayan
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/