Skip to contentSkip to conversation

Linux CBQ question

LARTC Udayan Borkar 1 participant 1 message Apr 30, 2002

lore
Share & tools
lore
#0 lore raw

Hi,

Question on Linux-CBQ. I have a Pentium 4 based PC running Redhat 7.2 (kernel 2.4.7) with 2 100-Base T ethernet interfaces (Eth0, Eth1). Traffic received on Eth0 is sent out on Eth1.

I am trying to restrict the outgoing traffic rate on Eth1 to 50Mbits/sec. However, when I use the configuration below, I find that the rate on Eth1 is about 5 Mbits/sec. If I delete the keywords bounded, isolated, I get a rate of 90 Mbits/sec. Measurements were made over an interval of 15 sec to 1 min)

On trying other Minburst, Maxburst values, the rate changes (e.g. Maxburst = 300, Minburst = 70) produces 25Mbits/sec etc.

(I was trying to create a hierarchy of classes whose total rate needs to be limited to 50Mbits/sec, I have managed to reduce the problem from that to this simplified configuration. I would prefer not to use HTB at the moment).

Can someone take a quick look at the configuration below and tell me what
I am doing wrong? (Ip address of Eth0=10.1.1.2, netmask=255.255.255.0; Eth1=10.1.2.2,netmask=255.255.255.0)

Thanks

Udayan

------------------

#!/bin/sh

sysctl -w net.ipv4.ip_forward=1

arp -s 10.1.2.4 00:80:AD:55:44:33

tc qdisc add dev eth1 root handle 1:0 cbq avpkt 1000 bandwidth 100Mbit mpu 64

tc class add dev eth1 parent 1:0 classid 1:1 cbq avpkt 1000 bandwidth 100Mbit cell 8 maxburst 5 minburst 1 minidle 10 mpu 64 rate 50Mbit allot 1500 prio 1 weight 5Mbit bounded isolated

tc qdisc add dev eth1 parent 1:1 bfifo limit 200000

tc filter add dev eth1 parent 1:0 protocol ip prio 1 u32 match ip dst 10.1.2.4/32 flowid 1:1

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/