Skip to contentSkip to conversation

Shaping and accounting

LARTC Rens Houben 2 participants 2 messages May 31, 2002

lore
Share & tools
lore
#0 lore raw

Hello,

A while ago now I had to set up a traffic shaper for the ISP I work
for, and I used linux and cbq.init to accomplish this. It worked reasonably well, too, but after a while and some double-checking it turned out that the ipac accounting on the same machine was consistently reporting higher usage than was actually the case by roughly the same factor (not amount) for every client.

After a lot of thinking about this, the only conclusion I could reach
that didn't involve a gross and so far completely undiscovered programming flaw in ipac or TCP/IP gremlins was that the difference was caused by traffic shaping occuring at the point where packets exit the machine while ipac does its accounting of packets at the point where they enter.

Am I right, or am I just blowing smoke and moondust, and in either
case, is there any way to correctly shape and account traffic on one machine?

Thanks,

Signature · 5 lines
Rens Houben                           |    opinions are mine
Resident linux guru and sysadmin      | if my employers have one
Systemec Internet Services.           |they'll tell you themselves
PGP public key at http://suzaku.systemec.nl/shadur.key.asc  -- new Dec
12 2001
#1 lore raw

Hi. yes afaik you're right: the ipac (for 2.2) and ipac-ng (vor 2.4) "just" insert iptables-rules in INPUT/OUTPUT/FORWARD, and so they don't see the "droped/delayed-because-of-shaping" packets..

the only solution i know is ugly and/or unpractiable: read the interface-stats from /proc/net/dev. but that's only usable, if
1. you have 1. interface/customer
2. you don't need to account certain ports

as i said: it's in most cases no solution...

With Patrick's imq-devices you can at least compute the "droped/delayed-because-of-shaping" packets: these imq-devices display in /proc/net/dev the ammount of packets/bytes that SHOULD have deliverd as RX, and the actual REALLY ammount of packets/bytes delivered to the interface as TX.

But that's not really useful for your setup :(

Greetings

Tobias

Quoted 20 lines

Hello,

A while ago now I had to set up a traffic shaper for the ISP I work
for, and I used linux and cbq.init to accomplish this. It worked reasonably well, too, but after a while and some double-checking it turned out that the ipac accounting on the same machine was consistently reporting higher usage than was actually the case by roughly the same factor (not amount) for every client.

After a lot of thinking about this, the only conclusion I could reach
that didn't involve a gross and so far completely undiscovered programming flaw in ipac or TCP/IP gremlins was that the difference was caused by traffic shaping occuring at the point where packets exit the machine while ipac does its accounting of packets at the point where they enter.

Am I right, or am I just blowing smoke and moondust, and in either
case, is there any way to correctly shape and account traffic on one machine?

Quoted 7 lines

Thanks,
--

Rens Houben                           |    opinions are mine
Resident linux guru and sysadmin      | if my employers have one
Systemec Internet Services.           |they'll tell you themselves PGP

public key at http://suzaku.systemec.nl/shadur.key.asc -- new Dec 12 2001

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/