Problems with routes
Whenever I try to 'readd' a route I receive an error and I can't figure out why...
# Add some routes
ip route add $EXT via $INT
ip route add prio 320 from $INT nat $EXT # Delete them
ip route del from $INT nat $EXT
ip route del $EXT via $INT
# Add again
ip route add $EXT via $INT
ip route add prio 320 from $INT nat $EXT
The last command exits with exit-code '2' and the message:
RTNETLINK answers: Invalid argument
What am I doing wrong?
Signature · 3 lines
Alexander Brill <[email protected]> http://www.project23.no PGP-key: http://alexb.egil.org/key.pub
Hello,
Quoted 6 lines · Alexander Brill
Whenever I try to 'readd' a route I receive an error and I can't figure out why...
# Add some routes
ip route add $EXT via $INT
ip route add prio 320 from $INT nat $EXT
ip rule add prio 320 from $INT nat $EXT
Quoted 2 lines
# Delete them
ip route del from $INT nat $EXT
ip route del prio 320 from $INT nat $EXT
Quoted 4 lines
ip route del $EXT via $INT
# Add again
ip route add $EXT via $INT
ip route add prio 320 from $INT nat $EXT
ip rule add prio 320 from $INT nat $EXT
Quoted 2 lines
The last command exits with exit-code '2' and the message:
RTNETLINK answers: Invalid argument
May be not only the last one :)
Quoted 1 line
What am I doing wrong?
Use ip rules for SNAT and ip routes for DNAT
Regards
--
Julian Anastasov <[email protected]>
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 26 lines · Julian Anastasov
Hello,
Quoted 6 lines · Alexander Brill
Whenever I try to 'readd' a route I receive an error and I can't figure out why...
# Add some routes
ip route add $EXT via $INT
ip route add prio 320 from $INT nat $EXTip rule add prio 320 from $INT nat $EXT
Quoted 2 lines
# Delete them
ip route del from $INT nat $EXTip route del prio 320 from $INT nat $EXT
Quoted 4 lines
ip route del $EXT via $INT
# Add again
ip route add $EXT via $INT
ip route add prio 320 from $INT nat $EXTip rule add prio 320 from $INT nat $EXT
Quoted 9 lines
Quoted 2 lines
The last command exits with exit-code '2' and the message:
RTNETLINK answers: Invalid argumentMay be not only the last one :)
Quoted 1 line
What am I doing wrong?
Use ip rules for SNAT and ip routes for DNAT
Thanks alot. Rather typical that you can't see your own typos ;)
Signature · 3 lines
Alexander Brill <[email protected]> http://www.project23.no PGP-key: http://alexb.egil.org/key.pub