Shape and Bridge which Interface to use?
hi list,
if tested linux bridging with the tc commands. but the kernel did not recognized my commands. the commands are from some howto´s. the should be correct. must i use the "bridge-interface"?
not eth0 and eth1? anyone some progress report to this situation?
thank you
greetings benny
--
Mit freundlichen Grüßen / Best regards
THALES COMMUNICATIONS GmbH
Benjamin Albrecht
Dept.: DP/CIT Tel.: +49-7231-15-3962 Fax.: +49-7231-15-3813 eMail: [email protected]
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Have you patched your kernel to allow access the bridge packets?
http://bridge.sourceforge.net
and also note that from what i have learned you had to use iptables, prerouting mangle table, to mark the packets then use tc filiters to put the packets into a qdics for shapping. and you could only shap out going traffic
you can also check out the bridges list serve @ [email protected] they are a good source for bridging problems
Chris
----- Original Message -----
From: "ALBRECHT, BENJAMIN" <[email protected]>
To: <[email protected]>
Sent: Tuesday, June 11, 2002 1:35 AM
Subject: [LARTC] Shape and Bridge which Interface to use?
hi list,
if tested linux bridging with the tc commands. but the kernel did not recognized my commands. the commands are from some howto´s. the should be correct. must i use the "bridge-interface"?
not eth0 and eth1? anyone some progress report to this situation?
thank you
greetings benny
--
Mit freundlichen Grüßen / Best regards
THALES COMMUNICATIONS GmbH
Benjamin Albrecht
Dept.: DP/CIT Tel.: +49-7231-15-3962 Fax.: +49-7231-15-3813 eMail: [email protected]
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/