Skip to contentSkip to conversation

how to filter based upon MAC

LARTC Adam B. Fineberg 3 participants 3 messages Jul 1, 2002

lore
Share & tools
lore
#1 lore raw
Quoted 3 lines · Adam B. Fineberg

It isn't obvious to me from the lartc howto or frmo the tc source how to set a filter to send all traffic destined for a specified MAC to a particular class. Any suggestions would be appreciated.

Hi,
I hardly think it is possible to send traffic for MAC address to a particular class.
I had tried it myself and failed miserably.
It all started when i wanted to control the "upload" traffic on my LAN.
I found out (from the lartc HOWTO) ,that you could mark packets using iptables based on the MAC source for incoming packets, on an incoming interface.
Then we send these marked packets to a destined class on the outgoing interface.

The basic problem is that you can only mark packets based on MAC for packets coming from an ethernet device.

--
arc_of_descent
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#2 lore raw
In reply to Adam B. Fineberg
Quoted 3 lines · Adam B. Fineberg

It isn't obvious to me from the lartc howto or frmo the tc source how to set a filter to send all traffic destined for a specified MAC to a particular class. Any suggestions would be appreciated.

I'm not sure, but can iptables mark packets based on Max address? If yes, you can use the fw filter to put the marked packets in a class.

Stef

Signature · 7 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.openprojects.net
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/