Skip to contentSkip to conversation

Ingress polices

LARTC Claudio Aznar 2 participants 2 messages Aug 7, 2002

lore
Share & tools
lore
#0 lore raw

Hi list,
I'm making BW control using filter police rate with ingress qdisc, it work fine but i have few question:

1. How to set different priorities for this filter, (I can dom it?), because if I set different priority, the filters are multiplied.
2. How I can combine different condition in only one filter, sharing the same BW of course. For example: port 80 and port 3128
with the same police rate of 128 Kbit. (Again, I can do it?).

The possible way is using classes and two interfaces, but the limitation is that I control port (protocols) in one interface (eth0) and clients (BW max for each) in other (eth1).

Thank in advance
Claudio Aznar
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 6 lines · Claudio Aznar

Hi list,
I'm making BW control using filter police rate with ingress qdisc, it work
fine but i have few question:

1. How to set different priorities for this filter, (I can dom it?),
because if I set different priority, the filters are multiplied.

There is only 1 filter, but there is a bug in the output of tc so the filter is printed more the once.

Quoted 4 lines

2. How I
can combine different condition in only one filter, sharing the same BW of course. For example: port 80 and port 3128 with the same police rate of 128 Kbit. (Again, I can do it?).

You can't do it. To do so, you will have to create a IMQ device, redirect all incoming traffic to it and use htb or cbq to create a hierarchical setup.

Stef

Signature · 7 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/