reset /proc/net/dev
HI List,
How do i reset the values in /proc/net/dev ?
This file holds values for count of each (packet && byte), (sent && received) through all interfaces.
I'm using a monitor which reads values from this file and prints out some nicely formatted output.
But i need to reset the values. ie. set then to zero. Restarting the network does not do what i want. I guess a reboot should do it.
Any other way?
--arc_of_descent
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Hi,
perhaps the only way (although untested) may be to "ip link set <interface> down" and to "rmmod <according-kernel-module>" which is in my opinion impractible :)
much nicer and easier:
create a simple rule matching everything incoming/outgoing your desired device and insert it in the PREROUTING/POSTROUTING chain. (or a custom rule to which is jumped in INPUT and FORWARD / OUTPUT and FORWARD)
e.g.
iptables -t nat -I PREROUTING -i eth0 # for incoming iptables -t nat -I POSTROUTING -o eth0 # for outgoing
or if u prefer not to use the nat table
e.g.
iptables -N eth0_out
iptables -N eth0_in
iptables -I INPUT -i eth0 -j eth0_in
iptables -I FORWARD -i eth0 -j eth0_in
iptables -I FORWARD -o eth0 -j eth0_out
iptables -I INPUT -o eth0 -j eth0_out
with "iptables -t nat -L -vx" / "iptables -L -vx" u can read bytes/packets and process this output in your script
hope that helps....
tobias
Quoted 13 lines
HI List,
How do i reset the values in/proc/net/dev?
This file holds values for count of each (packet && byte), (sent && received) through all interfaces.I'm using a monitor which reads values from this file and prints out some nicely formatted output.
But i need to reset the values. ie. set then to zero. Restarting the network does not do what i want. I guess a reboot should do it.
Quoted 7 lines
Any other way?
--
arc_of_descent
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 2 lines · Tobias Geiger thus
with "iptables -t nat -L -vx" / "iptables -L -vx" u can read bytes/packets and process this output in your script
Yes thanx
I've already used iptables for interesting
graphical output of traffic and bandwidth usage
But i just wanted to know how to reset/proc/net/dev/ cause its been bugging me
for a long time :-)
--arc_of_descent
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/