Skip to contentSkip to conversation

Best way to limit the rate

LARTC Mathieu Deziel 2 participants 2 messages Nov 29, 2002

lore
Share & tools
lore
#0 lore raw

Suppose you need to limit the rate of the traffic that flows in an HTB leaf class to 32kbits/sec

I can think of three ways to do it:

1.
make rate = ceil = 32kbit when creating this HTB leaf class. A pfifo qdisc can then be attached to this HTB leaf class to reduce the queue size, and therefore reduce the latency of the packets.

2.
Attach a TBF qdisc to this HTB leaf class, and configure it properly.

3.
Have a policing filter before the HTB leaf class that will limit the rate of the traffic before it enters the HTB leaf class.

Which one of these methods is the best?
My tests have shown that the latency of the packets is dramatically better with method 3. Anybody has an idea why this is the case?

--
Mathieu Deziel

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 5 lines · Mathieu Deziel

Suppose you need to limit the rate of the traffic that flows in an HTB leaf class to 32kbits/sec

I can think of three ways to do it:

Quoted 7 lines

1.
make rate = ceil = 32kbit when creating this HTB leaf class. A pfifo qdisc can then be attached to this HTB leaf class to reduce the queue size, and therefore reduce the latency of the packets.

2.
Attach a TBF qdisc to this HTB leaf class, and configure it properly.

HTB _is_ TBF. So the first idea is better. A ceiled htb class = tbf qdisc.

Quoted 7 lines

3.
Have a policing filter before the HTB leaf class that will limit the rate of the traffic before it enters the HTB leaf class.

Which one of these methods is the best?
My tests have shown that the latency of the packets is dramatically better with method 3. Anybody has an idea why this is the case?

Solution 3 has the advantage that you limit the packet at a rate, but you don't have a queue. The policer uses a small tbf queue to limit the packets. The packets are simply dropped if they exceed a certain rate. It's also not possible to share bandwidth like you can do with cbq/htb.

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/