Skip to contentSkip to conversation

tc filter and fwmark

LARTC Andrei Boros 2 participants 2 messages Dec 2, 2002 – Dec 3, 2002

lore
Share & tools
lore
#0 lore raw

Suppose:

ipchains -A forward -s inside_net -d 0/0 -j MASQ -m 100

(similar setup with iptables:
iptables -A PREROUTING -t nat -s inside_net -d 0/0 -j SNAT iptables -A PREROUTING -t nat -s inside_net -d 0/0 -j MARK --set_mark
100)

eth0 = outside iface
eth1 = inside iface

now:
tc filter add dev eth0 ... handle 100 fw
should catch packets marked by the above rule in ipchains (iptables).

Ok. When the packet returns, the masq/nat code will find it in it's table and demasquerade it (as if by an invisible inverse rule). Question:
Will the demasqueraded packets also bear the mark 100? And will
tc filter add dev eth1 handle 100 fw
Work?

I am probably missing something, as I haven't been able to make it work this way.
Any suggestions, please?
I want to shape the incoming traffic that I route for my inside network on the inside iface with queues and more complex shaping, rather then just a plain drop on the outside iface.

Thank you.

Signature · 7 lines
ing. Andrei Boros
mailto:[email protected] / +40-21-303-1870
Centrul pt. Tehnologia Informatiei
Societatea Romana de Radiodifuziune
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw
Quoted 12 lines · Andrei Boros

Suppose:

ipchains -A forward -s inside_net -d 0/0 -j MASQ -m 100

(similar setup with iptables:
iptables -A PREROUTING -t nat -s inside_net -d 0/0 -j SNAT iptables -A PREROUTING -t nat -s inside_net -d 0/0 -j MARK --set_mark
100)

eth0 = outside iface
eth1 = inside iface

Quoted 8 lines

now:
tc filter add dev eth0 ... handle 100 fw
should catch packets marked by the above rule in ipchains (iptables).

Ok. When the packet returns, the masq/nat code will find it in it's table and demasquerade it (as if by an invisible inverse rule). Question:
Will the demasqueraded packets also bear the mark 100?

No. The mask only exists =ion the firewall. If a packet leaves the firewall, the information is gone.

Quoted 3 lines

And will
tc filter add dev eth1 handle 100 fw
Work?

No.

Quoted 6 lines

I am probably missing something, as I haven't been able to make it work this way.
Any suggestions, please?
I want to shape the incoming traffic that I route for my inside network on the inside iface with queues and more complex shaping, rather then just a plain drop on the outside iface.

You have to mark the packets if they come from the internet. So the mark is still available if you want to shape the packets if they leave eth1.

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/