Skip to contentSkip to conversation

HTB quantum for small rates

LARTC Hannes Ebner 2 participants 2 messages Dec 22, 2002

lore
Share & tools
lore
#0 lore raw

hi devik,

i have found the following you have written some time ago:

Quoted 9 lines

It is important to know that for precise operation quantums need to be as small as possible and larger than MTU. Normaly you don't need to specify quantums manualy as HTB chooses precomputed values. It computes classe's quantum (when you add or change it) as its rate divided by r2q global parameter. Its default value is 10 and because typical MTU is 1500 the default is good for rates from 15 kBps (120 kbit). For smaller minimal rates specify r2q 1 when creating qdisc - it is good from 12 kbit which should be enough. If you will need you can specify quantum manualy when adding or changing the class.

what would be the best solution for rates smaller than 120kbit? i don't know how the higher rates are affected by scaling r2q down to 1, but would this be a solution for rates from 12kbit?

would it be better to calculate the quantum for each rate or to set a small quantum for all rates?

thanks in advance,
hannes

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 13 lines · Hannes Ebner

hi devik,

i have found the following you have written some time ago:

Quoted 9 lines

It is important to know that for precise operation quantums need to be as small as possible and larger than MTU. Normaly you don't need to specify quantums manualy as HTB chooses precomputed values. It computes classe's quantum (when you add or change it) as its rate divided by r2q global parameter. Its default value is 10 and because typical MTU is 1500 the default is good for rates from 15 kBps (120 kbit). For smaller minimal rates specify r2q 1 when creating qdisc - it is good from 12 kbit which should be enough. If you will need you can specify quantum manualy when adding or changing the class.

Quoted 6 lines

what would be the best solution for rates smaller than 120kbit? i don't know how the higher rates are affected by scaling r2q down to 1, but would this be a solution for rates from 12kbit?

would it be better to calculate the quantum for each rate or to set a small quantum for all rates?

The best you can do is following this rules and choose a good r2q :
- 1500 < rate_small / r2q
- rate_bigg / r2q < 60.000

with
- rate_small = smallest rate
- rate_bigg = biggest rate

Quantum is only used if you have 2 or more class fighting for remaining bandwidth from the same parent. And with remaining, I mean that each class already received it's rate and that the parent has some bandwidth left.

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/