Filter MAC address
Hi everyone,
I need to classified the traffic by looking at the packet destination and source MAC address. Can anyone here suggest ways to do this.
I have read through the HOWTO documentation, from there I know that U32 filter can only filter out IP or higher layer. May I know why U32 filter did not support datalink layer (MAC address)? Is it that when packet entering TC, the datalink layer no longer there? Are there any filter which can filter the MAC address?
Before this, I have successfully implement QoS through source and destination IP address using CBQ. Here I would like to thanks LARTC for the help.
Hope someone can help me this time... :) Thank you in advance!!!
Regards,
KB
---------------------------------
With Yahoo! Mail you can get a bigger mailbox -- choose a size that fits your needs
Quoted 9 lines · On Sun, 22 Dec 2002 07:33:24 +0000 (GMT) Qos Switch <[email protected]>…
Hi everyone,
I need to classified the traffic by looking at the packet destination and source MAC address. Can anyone here suggest ways to do this.
I have read through the HOWTO documentation, from there I know that U32 filter can only filter out IP or higher layer. May I know why U32 filter did not support datalink layer (MAC address)? Is it that when packet entering TC, the datalink layer no longer there? Are there any filter which can filter the MAC address?
Before this, I have successfully implement QoS through source and destination IP address using CBQ. Here I would like to thanks LARTC for the help.
Yes, you can do this, but using fw marking, not u32 classifier. Just search through the various netfilter extensions - you really can do miracles with them :))
E-gards,
Nickola
Hello,
Quoted 6 lines · Nickola Kolev
Quoted 6 lines
I need to classified the traffic by looking at the packet destination and source MAC address. Can anyone here suggest ways to do this.
I have read through the HOWTO documentation, from there I know that U32 filter can only filter out IP or higher layer. May I know why U32 filter did not support datalink layer (MAC address)? Is it that when
This is a lie.
Quoted 2 lines
Quoted 2 lines
packet entering TC, the datalink layer no longer there? Are there any filter which can filter the MAC address?
You can filter with U32 by src/dst MAC on ingress and
by dst MAC on egress. On egress the src MAC is replaced with new one and there is no good reason to apply U32 filters for sender's MAC.
Quoted 6 lines
Quoted 4 lines
Before this, I have successfully implement QoS through source and destination IP address using CBQ. Here I would like to thanks LARTC for the help.
Yes, you can do this, but using fw marking, not u32 classifier. Just
Why not, just use negative offsets with U32 to access
the 14-byte eth frame header before the IP header:
Decimal Ofs Description
-----------------------------------
-14: DST MAC, 6 bytes
-8: SRC MAC, 6 bytes
-2: Eth PROTO, 2 bytes, eg. ETH_P_IP
0: Protocol header (IP Header)
Quoted 5 lines
search through the various
netfilter extensions - you really can do miracles with them :))E-gards,
Nickola
Regards
--
Julian Anastasov <[email protected]>
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/