Skip to contentSkip to conversation

Routing between two RFC1918 networks.

LARTC Dave Hunt 2 participants 2 messages Dec 30, 2002

lore
Share & tools
lore

Dave Hunt

author
#0 lore raw

Hi all,

I've two RFC1918 networks with a RedHat Linux 7.3 box in the middle. They are 10.4.2.0 and 10.4.7.0. There are a couple of boxes on each network,
but I can't ping a box on one network from the other.

Destination Gateway Genmask Flags Metric Ref Use
Iface
217.78.4.128 * 255.255.255.192 U 0 0 0
eth2
10.4.7.0 * 255.255.255.0 U 0 0 0
eth3
10.4.2.0 * 255.255.255.0 U 0 0 0
eth0
192.168.200.0 * 255.255.255.0 U 0 0 0
eth1
127.0.0.0 * 255.0.0.0 U 0 0 0
lo
default 217.78.4.190 0.0.0.0 UG 0 0 0
eth2

The above is the routing table of the machine. All iptables policies are set to accept.
I can access the internet fine from the 192 and 10 networks, as masquerading is enabled on eth2.
However, I do not want to masquerade the address from 10.4.2.0 onto 10.4.7.0
and vice-versa.
Am I missing something obvious?
Cheers,
Dave.

#1 lore raw

-----BEGIN PGP SIGNED MESSAGE-----
Hash: SHA1

Just a hunch: is forwarding enabled? i.e., 'echo 1 > /proc/sys/net/ipv4/ip_forward'

Quoted 5 lines · Dave Hunt

Hi all,

I've two RFC1918 networks with a RedHat Linux 7.3 box in the middle. They are 10.4.2.0 and 10.4.7.0. There are a couple of boxes on each

network,

Quoted 5 lines

but I can't ping a box on one network from the other.

Destination Gateway Genmask Flags Metric Ref Use
Iface
217.78.4.128 * 255.255.255.192 U 0 0

0 eth2

Quoted 1 line

10.4.7.0 * 255.255.255.0 U 0 0

0 eth3

Quoted 1 line

10.4.2.0 * 255.255.255.0 U 0 0

0 eth0

Quoted 1 line

192.168.200.0 * 255.255.255.0 U 0 0

0 eth1

Quoted 2 lines
127.0.0.0       *               255.0.0.0       U     0      0        0 lo
default         217.78.4.190    0.0.0.0         UG    0      0

0 eth2

Quoted 12 lines

The above is the routing table of the machine. All iptables policies are set to accept.
I can access the internet fine from the 192 and 10 networks, as masquerading is enabled on eth2.
However, I do not want to masquerade the address from 10.4.2.0 onto 10.4.7.0
and vice-versa.
Am I missing something obvious?
Cheers,
Dave.

Quoted 4 lines

--
This message has been scanned for viruses and
dangerous content by *MailScanner* <http://www.mailscanner.info/>, and is believed to be clean.

- --
Jason A. Pattie
[email protected]
-----BEGIN PGP SIGNATURE-----
Version: GnuPG v1.0.6 (GNU/Linux)
Comment: Using GnuPG with Mozilla - http://enigmail.mozdev.org

iD8DBQE+EG6KuYsUrHkpYtARAqUXAJ960GrM0q2N9r5w408H3PZ9nVRbxwCgggvy r3745Y0oFWzeh/CjPBncht4=BOMI
-----END PGP SIGNATURE-----

Signature · 7 lines
This message has been scanned for viruses and
dangerous content by MailScanner, and is
believed to be clean.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/