Skip to contentSkip to conversation

Setup IMQ on kernel 2.4.20

LARTC Koot, M. 2 participants 2 messages Jan 9, 2003

lore
Share & tools
lore
#1 lore raw

Yes, no problem.

Just take a look to the attached files.

Regards

Remus

----- Original Message -----
From: "Koot, M." <[email protected]>
To: "List LARTC" <[email protected]>
Sent: Thursday, January 09, 2003 8:02 AM
Subject: [LARTC] Setup IMQ on kernel 2.4.20

Quoted 7 lines

Hi,

does someone have setup IMQ succesfully on kernel 2.4.20? If so, how did you do that.
I only see the diff for kernel 2.4.19. Can I use that?

Quoted 9 lines

Thanks,

Martijn

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

You can successfully run iptables 1.2.7a with patch from IMQ homepage. The thing what you have to do is to replace strings contains:
NETFILTER_VERSION to "1.2.7a" in libipt_IMQ.c and libip6t_IMQ.c .

How to patch iptables and 2.4.xx kernel:

cd iptables-1.2.7a
patch -p1 < ./iptables-1.2.7a-imq.diff
chmod a+x extensions/.IMQ-test
chmod a+x extensions/.IMQ-test6

cd linux-2.4.20
patch -p1 < ./imq-2.4.19.diff

cd patch-o-matic-YYYYMMDD
patch -p1 < ./pom-imq.diff KERNEL_DIR=/usr/src/linux-2.4.20 ./runme extra/IMQ.patch

You will have three new options:
Networking options ---> IP: Netfilter Configuration --->IMQ target support Networking options ---> IPv6: Netfilter Configuration --->IMQ target support Network device support --->IMQ (intermediate queueing device) support

Choose at least one of the targets and the device itself.
Netfilter debugging should be turned off, otherwise cou get lots of annoying messages.