Skip to contentSkip to conversation

Bandwith limiting, simple solution?

LARTC Martin A. Brown 1 participant 1 message Mar 1, 2003

lore
Share & tools
lore
#0 lore raw

John,

: First of all, let me warn you, im not a deep *nix dude, i've used linux : for some time now but never at this level, so bare with me.

Flasher! :) {You meant "bear with me"}

: I know my question most likely could be solved by reading the HOWTO, : however, i wanted to hear if someone knew a simple and fast solution : before i start reading 100's of pages.

Traffic control isn't terribly difficult, but it is conceptual. I'd recommend reading the LARTC HOWTO [1] and Stef Coene's site [2].

: It's quite simple, i want to limit up outgoing traffic to 128kbit. All : incoming should remain as maximum, only the outgoing should be : affected.

Well....since incoming and outgoing are required for any connection, you'll have to approach this from a different angle when you get ready to write some traffic control classifiers (tc filter).

: Though, IF possible and not a MUST, i would like the intern network to : remain 100mbit.

No problem. Take a look at the KPTD [3] to see that traffic control is just about the last thing that happens to an outbound packet.

: Anyone know a simple solution to this?

Simplest place to start would be the wondershaper [4], but you'll need to tweak it if you intend to just cap the bandwidth available for connections initiated from the inside.

Good luck,

-Martin

 [1]  http://lartc.org/howto/
 [2]  http://www.docum.org/
 [3]  http://www.docum.org/stef.coene/qos/kptd/
 [4]  http://lartc.org/wondershaper
Signature · 5 lines
Martin A. Brown --- SecurePipe, Inc. --- [email protected]

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/