Wonder shaper between two ethernet links
This is quiet possibly a simple and obvious question but I'm only getting to grips with traffic shaping and filtering. I have a firewall with two ethernet connections, one internal (eth0) and one external to a modem (eth1). I'm trying to set up a filter on eth1 that will give interactive traffic high priority outgoing and limit downloads to a fixed rate. This is what I thought wondershaper was meant to do.
However, on the last line of the script
tc filter add dev $DEV parent ffff: protocol ip prio 50 u32 match ip src \
0.0.0.0/0 police rate ${DOWNLINK}kbit burst 10k drop flowid :1
All traffic will be dropped and I can't figure out why. Any help would be appreciated or at least a pointer to the right section to start reading. Rooting through the archives didn't seem to have an obvious answer and neither did the HOWTO but that is likely to be my pooor understanding more than anything else
Thanks
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 9 lines · Mel Gorman
This is quiet possibly a simple and obvious question but I'm only getting to grips with traffic shaping and filtering. I have a firewall with two ethernet connections, one internal (eth0) and one external to a modem (eth1). I'm trying to set up a filter on eth1 that will give interactive traffic high priority outgoing and limit downloads to a fixed rate. This is what I thought wondershaper was meant to do.
However, on the last line of the script
Quoted 8 lines
tc filter add dev $DEV parent ffff: protocol ip prio 50 u32 match ip src \
0.0.0.0/0 police rate ${DOWNLINK}kbit burst 10k drop flowid :1All traffic will be dropped and I can't figure out why. Any help would be appreciated or at least a pointer to the right section to start reading. Rooting through the archives didn't seem to have an obvious answer and neither did the HOWTO but that is likely to be my pooor understanding more than anything else
I can remember me a problem with this line. Do you have ingress support in your kernel?
Stef
Signature · 8 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 3 lines · Stef Coene
I can remember me a problem with this line. Do you have ingress support in your kernel?
Yes, compiled as a module(sch_ingress) and it is definetly loaded
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 5 lines · Mel Gorman
Quoted 2 lines · Stef Coene
I can remember me a problem with this line. Do you have ingress support in your kernel?
Yes, compiled as a
module(sch_ingress)and it is definetly loaded
I searched the archives, but I coudn't find anything.
As fas as I remember me, it was a config problem.
Do you have tc binary with ingress support? You can enable this if you change the Config file in the iproute2 source:
TC_CONFIG_DIFFSERV=y
Stef
Signature · 8 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/