Skip to contentSkip to conversation

shared_media

LARTC Marco Berizzi 2 participants 3 messages May 12, 2003

lore
Share & tools
lore
#0 lore raw

Hello everybody.

I have a problem with my firewall rules on my Slackware Linux box 9.0 (kernel 2.4.20-xfs).
This system is configured with 3 NIC (one for the router, one for the dmz, and the other for the private net).
I have written a firewall (iptables) that is processing packet based also on the incoming interface.
This firewall is connected in a not good environment where all the NIC (and the router) are connected to the same switch (don't ask me why). Here is the problem: an incoming packet from the private net sometimes is catched by the priv NIC, sometimes is catched by the DMZ nic and sometimes is catched by router NIC. This happens (I think) because when a client (windoze) sends an arp request with the priv NIC IP, linux replies with the MAC address from any of the 3 NIC and not only with the MAC from the priv NIC.

Is there any setting in /proc to prevent this? shared_media perhaps?

TIA

PS: Please cc me. I'm not receiving messages from this list.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

Dear Marco,

Linux, in the 2.4 kernels, has this default behaviour. The ARP reply for an IP goes from any interface on the system, not just the one on which the IP is configured.

You can change this behaviour by setting:

/proc/sys/net/ipv4/conf/all/arp_filter = 1

Or, if you want to control this for just one interface:

/proc/sys/net/ipv4/conf/interface name e.g. eth0/arp_filter = 1

As an aside, I would also recommed setting up different VLANs, if your switch support them. That way you can get different "logical" switches.

Regards,
-Varun

Quoted 17 lines · Marco Berizzi

Hello everybody.

I have a problem with my firewall rules on my Slackware Linux box 9.0 (kernel 2.4.20-xfs).
This system is configured with 3 NIC (one for the router, one for the dmz, and the other for the private net).
I have written a firewall (iptables) that is processing packet based also on the incoming interface.
This firewall is connected in a not good environment where all the NIC (and the router) are connected to the same switch (don't ask me why). Here is the problem: an incoming packet from the private net sometimes is catched by the priv NIC, sometimes is catched by the DMZ nic and sometimes is catched by router NIC. This happens (I think) because when a client (windoze) sends an arp request with the priv NIC IP, linux replies with the MAC address from any of the 3 NIC and not only with the MAC from the priv NIC.

Quoted 8 lines

Is there any setting in /proc to prevent this? shared_media perhaps?

TIA

PS: Please cc me. I'm not receiving messages from this list.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#2 lore raw
In reply to Marco Berizzi

Hi Varun,

Thanks a lot for the reply. That's what I was looking for.

----- Original Message -----
From: "Varun Varma" <[email protected]>
To: "Marco Berizzi" <[email protected]>
Cc: <[email protected]>
Sent: Monday, May 12, 2003 1:10 PM
Subject: Re: [LARTC] shared_media

Quoted 3 lines

Dear Marco,

Linux, in the 2.4 kernels, has this default behaviour. The ARP reply

for

Quoted 5 lines

an IP goes from any interface on the system, not just the one on which the IP is configured.

You can change this behaviour by setting:

Quoted 8 lines

/proc/sys/net/ipv4/conf/all/arp_filter = 1

Or, if you want to control this for just one interface:

/proc/sys/net/ipv4/conf/interface name e.g. eth0/arp_filter = 1

As an aside, I would also recommed setting up different VLANs, if your switch support them. That way you can get different "logical"

switches.

Quoted 8 lines

Regards,
-Varun

Quoted 3 lines · Marco Berizzi

Hello everybody.

I have a problem with my firewall rules on my Slackware Linux box

9.0

Quoted 2 lines
Quoted 2 lines

(kernel 2.4.20-xfs).
This system is configured with 3 NIC (one for the router, one for

the

Quoted 4 lines
Quoted 4 lines

dmz, and the other for the private net).
I have written a firewall (iptables) that is processing packet based also on the incoming interface.
This firewall is connected in a not good environment where all the

NIC

Quoted 1 line
Quoted 1 line

(and the router) are connected to the same switch (don't ask me

why).

Quoted 1 line
Quoted 1 line

Here is the problem: an incoming packet from the private net

sometimes

Quoted 2 lines
Quoted 2 lines

is catched by the priv NIC, sometimes is catched by the DMZ nic and sometimes is catched by router NIC. This happens (I think) because

when

Quoted 2 lines
Quoted 2 lines

a client (windoze) sends an arp request with the priv NIC IP, linux replies with the MAC address from any of the 3 NIC and not only with

the

Quoted 1 line
Quoted 1 line

MAC from the priv NIC.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/