Skip to contentSkip to conversation

ethernet bonding ?

LARTC Christian Purnomo 2 participants 2 messages May 23, 2003

lore
Share & tools
lore
#0 lore raw

HI All.

I have a linux box connected to a switch network with 2 network interfaces, how would I able to 'trunk' these 2 interfaces? options I can see are:
- ethernet bonding
- iproute2?
- teql

Which one are the best to use?

I'm curretly having problem with ethernet bonding, my setup are as follow:
ip add: 192.168.10.30/24

I do:

# modprobe bonding
# ip addr add 192.168.10.30/24 dev bond0
# ifenslave bond0 eth0
# ifenslave bond0 eth1
# ip link set bond0 up

At this stage, I can't ping any of the other workstations / server in 192.168.10.0/24 subnet. I run tcpdump on both the bonding machine and the server I am pinging, I can see the bonding machine keeps sending arp request, the server recevies the arp request and also sends a reply back... but it seems the arp reply never get through to the bonding machine. Has anyone experience this issue?

PS: I have just subscribed to this mailling list, have been fiddling alot with LARTC, cool stuff I must say!

Thanks in advanced

Christian.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw

Christian,

: I have a linux box connected to a switch network with 2 network : interfaces, how would I able to 'trunk' these 2 interfaces? options I : can see are:

For trunking, link aggregation, you need to have support for 802.3ad in your switch, and you must configure your switch appropriately, in addition to the commands you ran on your linux box.

: - ethernet bonding

The documentation is extensive and thorough on bonding! OK, so I exaggerate. Check out Documentation/networking/bonding.txt in the kernel source tree. Yes, you probably already knew that.

: - iproute2?

Not to my knowledge.

: - teql

Yes, you can use teql. The LARTC HOWTO has a good example of using teql.

: Which one are the best to use?

Depends on your application. I'd recommend trunking if and only if your switch supports it. Heh.

: I'm curretly having problem with ethernet bonding, my setup are as follow:
: ip add: 192.168.10.30/24
:
: I do:
:
: # modprobe bonding
: # ip addr add 192.168.10.30/24 dev bond0
: # ifenslave bond0 eth0
: # ifenslave bond0 eth1
: # ip link set bond0 up
:
: At this stage, I can't ping any of the other workstations / server in : 192.168.10.0/24 subnet. I run tcpdump on both the bonding machine and : the server I am pinging, I can see the bonding machine keeps sending : arp request, the server recevies the arp request and also sends a reply : back... but it seems the arp reply never get through to the bonding : machine. Has anyone experience this issue?

Have you configured the switch to trunk the two ports to which your linux box has physical connections?

-Martin

Signature · 5 lines
Martin A. Brown --- SecurePipe, Inc. --- [email protected]

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/