Skip to contentSkip to conversation

u32 filter and NAT

LARTC Szymon Miotk 2 participants 2 messages May 29, 2003 – May 30, 2003

lore
Share & tools
lore
#0 lore raw

I want to limit each user in my network to have limited bandwidth (let's
say 256/128 kbit).
I use NAT (done with iptables).
Can I limit users on the outgoing interface using u32 using rules like:

tc filter add dev eth0 parent 1: protocol ip prio 17 u32 match ip src 10.10.10.10 flowid 1:10

It seem I made a mistake somewhere or NAT is done before routing and I must use iptables mangling. BTW what is the maximum for --set-mark ?

Thanks!

Szymon Miotk

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 10 lines · Szymon Miotk

I want to limit each user in my network to have limited bandwidth (let's
say 256/128 kbit).
I use NAT (done with iptables).
Can I limit users on the outgoing interface using u32 using rules like:

tc filter add dev eth0 parent 1: protocol ip prio 17 u32 match ip src 10.10.10.10 flowid 1:10

It seem I made a mistake somewhere or NAT is done before routing and I must use iptables mangling.

The src address is indeed rewritten. So you have to mark the packets with iptables before natting and use that mark with the fw filter.

Quoted 1 line

BTW what is the maximum for --set-mark ?

Mark is 32 or so, so you can go pretty high.

Stef

Signature · 8 lines
[email protected]
 "Using Linux as bandwidth manager"
     http://www.docum.org/
     #lartc @ irc.oftc.net

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/