Skip to contentSkip to conversation

IMQ / how to put incoming traffic to the gateway and to the LAN in

LARTC [email protected] 1 participant 2 messages Jun 4, 2003 – Jun 5, 2003

lore
Share & tools
lore
#0 lore raw

Hi,

My setup is:
LAN --(eth0)-- GW/FW --(ppp0)-- Internet

How to distinguish incoming traffic to the gateway from the traffic to the LAN ?

I'm using 'iptables -t mangle -A PREROUTING -j IMQ -i ppp0' to send incoming traffic to imq0
Now I would like to put incoming traffic to the gateway and incoming traffic to the lan in two different classes.
I tried 'iptables -t mangle -A POSTROUTING -o eth0 -m mark --mark 0x1 -j IMQ' and 'iptables -t mangle -A FORWARD -i ppp0 -o eth0 -j MARK --set-mark 0x1' But it's wrong because the incoming traffic to the LAN goes twice to imq0.

Is there a way to do that correctly ?

Signature · 4 lines
S.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
#1 lore raw

Re: [LARTC] IMQ / how to put incoming traffic to the gateway and to

[email protected] writes:

Hi again

I'm not sure I made myself clear.

Before using IMQ I was using ingress on ppp0 and egress on eth0 to police incoming traffic to the LAN.

Now i'm using IMQ. I would like to do something like that:

iptables -t mangle -A PREROUTING -j IMQ -i ppp0
iptables -t mangle -A FORWARD -i ppp0 -o eth0 -j MARK --set-mark 0x10 iptables -t mangle -A POSTROUTING -o eth0 -m mark --mark 0x10 -j IMQ

but it's wrong, incoming traffic to my LAN is being queued twice to imq.

Here is a simple example of what I would like to do:
2 htb classes bounded to imq0 (classid 1:10 and 1:20), i'd like to put incoming traffic destinated to the gateway in 1:10. And incoming traffic destinated to the NATed LAN in 1:20.

Is there a way to correctly do that ?
Is there anybody who understands me ? :-)

Quoted 8 lines

My setup is:
LAN --(eth0)-- GW/FW --(ppp0)-- Internet
How to distinguish incoming traffic to the gateway from the traffic to the LAN ?
I'm using 'iptables -t mangle -A PREROUTING -j IMQ -i ppp0' to send incoming traffic to imq0
Now I would like to put incoming traffic to the gateway and incoming traffic to the lan in two different classes.
I tried 'iptables -t mangle -A POSTROUTING -o eth0 -m mark --mark 0x1 -j IMQ' and 'iptables -t mangle -A FORWARD -i ppp0 -o eth0 -j MARK --set-mark 0x1' But it's wrong because the incoming traffic to the LAN goes twice to imq0.
Is there a way to do that correctly ?

Signature · 3 lines
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/