Skip to contentSkip to conversation

R: [LARTC] time window in CBQ

DISCUSSION Andreani Luca 5 participants 6 messages Sep 5, 2003

lore
Share & tools
lore
#0 lore raw

-----Messaggio originale-----
Da: Steve Wright [mailto:[email protected]]
Inviato: venerdì 5 settembre 2003 11.31
A: Andreani Luca
Oggetto: Re: [LARTC] time window in CBQ

Quoted 10 lines · Andreani Luca

Dear list,

I have two linux boxes acting as VoIP Gateway in the following configuration:

        IP Phone ----------+                
+------------------+                         
+------------------+                  +---------------- IP Phone
Quoted 7 lines
                         |-----------eth0-| Linux BOX1
|-hdlc0----------hdlc0-| Linux BOX2 |-hdlc0-----------|
        PC ----------------- -+                
+------------------+                         
+-----------------+                   +--------------- PC

The hdlc link is 64 kbps.

is 64kbit/sec enough for VoIP ? I would have thought not.. but I do not have VoIP...

/steve

#3 lore raw
In reply to Andreani Luca

Hi Steve,

Quoted 5 lines
Quoted 2 lines

is 64kbit/sec enough for VoIP ? I would have thought not.. but I do not have VoIP...

Steve, what voip codec do you use?
If you can select, use G723 (6.3 kbit/s)

yep, 64kBit is fine with GnomeMeeting. You should use Speex8k though, as there's a huge protocol overhead that needs to be added to that number of x.y kBit/s.. (many small packets)

Empirically Speex8k works fine and MS-GSM might also do. The G.723 does require a hardware extension and is not available with pure software. Feel free to search the GnomeMeeting archives for details on configurations. ;)

Signature · 2 lines
Best regards,
 Kilian
#4 lore raw
In reply to Andreani Luca
Quoted 7 lines · Catalin BOIE
Quoted 2 lines · Andreani Luca

is 64kbit/sec enough for VoIP ? I would have thought not.. but I do not have VoIP...

Steve, what voip codec do you use?
If you can select, use G723 (6.3 kbit/s)

ahh, but I do not have VoIP. I am planning still.

/sw

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#5 lore raw
In reply to Andreani Luca

I must recommend against using G723 unless you are in a very bandwidth starved but high reliability situation. VOIP is extremely time sensitive, and the latency involved in compression greatly reduces your margin for error. G711 uses more bandwidth (64k per call is a reasonable figure, but it depends on packetization), but will be considerably more forgiving to jitter.

Quoted 7 lines · Catalin BOIE
Quoted 2 lines · Andreani Luca

is 64kbit/sec enough for VoIP ? I would have thought not.. but I do not have VoIP...

Steve, what voip codec do you use?
If you can select, use G723 (6.3 kbit/s)

Quoted 8 lines
Quoted 1 line

/steve

---
Catalin(ux) BOIE
[email protected]
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/