problem with htb restriction
I have the next config in a firewall:
[router]
|
[Firewall]
eth0: 200.x.x.x (public address)
eth1: 192.168.44.1 (private address)
|[LAN] (192.168.44.0/24)
The router has a DS0 with 64kbit connection to internet(yes, that slow) and the firewall makes nat to the private class.
I want that port 25 traffic(MTA) always have 4kbps and port 80 traffic, another 4kbps.
I made this:
tc qdisc add dev eth0 root handle 1: htb default 12
tc class add dev eth0 parent 1: classid 1:1 htb rate 8kbps ceil 8kbps tc class add dev eth0 parent 1:1 classid 1:10 htb rate 4kbps ceil 8kbps tc class add dev eth0 parent 1:1 classid 1:11 htb rate 4kbps ceil 8kbps tc filter add dev eth0 protocol ip parent 1:0 prio 1 u32 match ip src \
192.168.44.0/24 match ip dport 25 0xffff flowid 1:10
tc filter add dev eth0 protocol ip parent 1:0 prio 1 u32 match ip src \
192.168.44.0/24 match ip dport 80 0xffff flowid 1:11
But from a machine of the class 192.168.44 (fw as gateway) I made a test to an external http server and had no limit on port 80 traffic.
What can be wrong?
Is it necessary to add the same rules with eth1?
Omar
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/
Quoted 13 lines · Omar Armas
[router]
| [Firewall] eth0: 200.x.x.x (public address) eth1: 192.168.44.1 (private address) |[LAN] (192.168.44.0/24)
tc filter add dev eth0 protocol ip parent 1:0 prio 1 u32 match ip src \
192.168.44.0/24 match ip dport 250xffffflowid 1:10
tc filter add dev eth0 protocol ip parent 1:0 prio 1 u32 match ip src \
192.168.44.0/24 match ip dport 800xffffflowid 1:11
Quoted 2 lines
But from a machine of the class 192.168.44 (fw as gateway) I made a test to an external http server and had no limit on port 80 traffic.
The htb qdisc is going to rate limit the traffic _leaving_ the interface. so the rules you've created above will only slow down the HTTP requests to the internet, not the HTTP data downloaded from the external servers.
Quoted 1 line
Is it necessary to add the same rules with eth1?
I think you should be able to move them all to eth1, and remove them from eth0. You'll also want to change the 'src' to 'dst'.
regards.
Signature · 11 lines
~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ Damion de Soto - Software Engineer email: [email protected] SnapGear --- ph: +61 7 3435 2809 | Custom Embedded Solutions fax: +61 7 3891 3630 | and Security Appliances web: http://www.snapgear.com ~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~~ --- Free Embedded Linux Distro at http://www.snapgear.org --- _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/