Skip to contentSkip to conversation

bridging troubles

LARTC Padraig Brady 1 participant 2 messages Nov 24, 2003

lore
Share & tools
lore
#0 lore raw

Hi, I would like to be able to control the slave devices of a bridge independently of the bridge interface. For e.g. if I have eth0 and eth1 in a bridge eth0-eth1, then I the following doesn't give an error, but doesn't actually work either?

ip link set dev eth0 promisc on

However this does work?

ip link set dev eth0 down

Is this a bug?

cheers,
Pádraig.

p.s. the bridge mailing list web site doesn't work

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 11 lines · Robert Kurjata

Witaj Padraig,

W Twoim liœcie datowanym 24 listopada 2003 (14:18:04) mo¿na przeczytaæ:

PB> Hi, I would like to be able to control
PB> the slave devices of a bridge independently
PB> of the bridge interface. For e.g. if I have
PB> eth0 and eth1 in a bridge eth0-eth1, then
PB> I the following doesn't give an error,
PB> but doesn't actually work either?

Quoted 4 lines

PB> ip link set dev eth0 promisc on

AFAIR in the bridge the interfaces MUST be in promisc mode for the bridge to work at all. So the command above has no meaning.

Well it does if I want to stop traffic temporarily.

Quoted 3 lines

PB> However this does work?

PB> ip link set dev eth0 down

this does stop traffic temporarily, but
has other side affects I don't want.

Pádraig.

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/