Skip to contentSkip to conversation

Grouping Interfaces

LARTC Rus Foster 1 participant 1 message Dec 4, 2003

lore
Share & tools
lore

Rus Foster

author
#0 lore raw

Hi All,
I'm a newbie to Linux routing and I've read the HOWTO more times than I
care to remeber. Now I've managed to get simple rate limiting working on my primary eth0 with no problem. However what I've got is as follows

eth0 is on 100Mbit

I'm running User Mode Linux so I've got say 5-10 tap interfaces (tap0-tap10). What I would like to do is have a combined pool of 3Mbit which each interface can burst to but make sure that the total off all of them does not break 3mbits.

Is this possible?

Rus

Signature · 9 lines
w: http://www.jvds.com  | Just Virtual Dedicated Servers
e: [email protected]        | banners: http://www.jvds.com/banners.php
t: +44 7919 373537	|
t: 1-888-327-6330 	| email: [email protected]


_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/