Skip to contentSkip to conversation

Help: howto config mail server with 2 internet provider?

LARTC masroor 2 participants 2 messages Dec 6, 2003

lore
Share & tools
lore

masroor

author
#0 lore raw

hello,
I want to send/receive email thru second internet line when the first line
is disconnected and back to first line when it get on again automattically.

my mail server is postfix on redhat 9. and it have 2 ethernet cards which everyone connected to it's internet line.

i tried this:
http://linux-ip.net/html/adv-multi-internet.html
but it didn't work.

please someone give me more advice about doing it step by step.

Thanks in advanced,
masroor

--
IUT WebMail Service at CIS (https://cc.iut.ac.ir/webmail/)

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/

#1 lore raw
Quoted 13 lines · masroor

I want to send/receive email thru second internet line when the first line
is disconnected and back to first line when it get on again automattically.

my mail server is postfix on redhat 9. and it have 2 ethernet cards which everyone connected to it's internet line.

i tried this:
http://linux-ip.net/html/adv-multi-internet.html
but it didn't work.

please someone give me more advice about doing it step by step.

I've glanced over your quoted document, it looks like a policy routing example for a multihomed NATed internet site. Your description of need doesn't indicate you want agregate bandwidth just failover.

Some food for thought:

* Is the mail server and LANs default router the same box ?
* Are the interfaces for both primary and backup directly connected to the same box ? If so, How ?
* Are both internet connections NATed ? or routed ?
* You need to confirm the reliability of the mechanism the router uses to know when the primary Internet link has failed.
* If your requirement is as simplictic as wanting a backup to be used only when the primary link fails, maybe setup two default routes in your routing table with a lower metric on the primary route. In the event the link goes down I presume the interface will also go into down state, and therefore the routing entry will be removed implicitly by the kernel. The backup route with the higher metric will then be selected for default routing.
* Actually test the situation where your primary link fails and confirm the host it's directly connected to can detect this and does bring that interface down.

In the situation where the mail host and LANs default router is the same box and the two Internet links are suppled on dedicated ethernet interfaces:

# Primary link via gateway 10.0.0.1 on eth0
route add -net default gw 10.0.0.1 dev eth0

# Backup link via gateway 10.0.1.1 on eth1 route add -net default gw 10.0.1.1 metric 1 dev eth1

One area to look at is how the default route is added when the backup link comes up, this would usualy mean altering the configuration to how the backup link add's its default route, you simply add the "metric 1" into the route command at this point.

Darryl

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/