Skip to contentSkip to conversation

Modelling a slow [56K connection] to specific computers on a LAN

LARTC Yusuf Goolamabbas 2 participants 2 messages May 4, 2001

lore
Share & tools
lore
#0 lore raw

Hi, I am currently using Linux 2.2.19 and am attached to many other boxes on a switched 100 Mbit Lan. For some experiments, I would like to model a 56K dial-up connection to a webserver on one machine [maybe more] on the LAN. Techniques regarding modelling the speed in the inbound direction only would be appreciated

I have read [more like skimmed through the Linux 2.4 Advanced Routing HowTO but am not sure if that is applicable to 2.2 and scenario's where the machine is not a router but a host]. I am more familiar with FreeBSD ipfw and dummynet but don't want to setup a separate traffic shaper box in bridging mode for this

my question is, Is this possible in Linux 2.2. I don't compile my kernel's with firewall support. Is this a requirement

Thanks, Yusuf

Signature · 6 lines
Yusuf Goolamabbas
[email protected]

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/
#1 lore raw
Quoted 9 lines

Hi, I am currently using Linux 2.2.19 and am attached to many other boxes on a switched 100 Mbit Lan. For some experiments, I would like to model a 56K dial-up connection to a webserver on one machine [maybe more] on the LAN. Techniques regarding modelling the speed in the inbound direction only would be appreciated

I have read [more like skimmed through the Linux 2.4 Advanced Routing HowTO but am not sure if that is applicable to 2.2 and

                                        ^^^^^^^^^^^^^^^^^^^^^^

I have tried and it's successful.
But you have to make your kernel to support CBQ like below
----------------------------------------------------------------------------
--------
NETWORK OPTION
open IP: use TOS valus as routing key open IP: use FWMARK valus as routing key open IP: advanced router
open IP: policy routing

NETWORK OPTION --> QoS and/or fair queueing(last option) <M>CBQ
<M>CSZ
<M>The simplest PRIO pseudoscheduler
<M>RED
<M>SFQ
<M>TEQL
<M>TBF
<*>QoS support
<*>Rate estimator
<*>Packet classifier API
<M>Routing table based classifier
<M>Firewall
<M>U32
<M>Special RSVP classifier
<M>Special RSVP classifier FOR IPv6
<*>Ingres traffic policing
----------------------------------------------------------------------------
--------

And then you can use iproute to add CBQ to your network interface.

Quoted 6 lines

scenario's where the machine is not a router but a host]. I am more familiar with FreeBSD ipfw and dummynet but don't want to setup a separate traffic shaper box in bridging mode for this

my question is, Is this possible in Linux 2.2. I don't compile my kernel's with firewall support. Is this a requirement

                                                ^^^^^^^^^^^^^^^^

no...it's not the same thing.
CBQ is for the bandwidth management....and firewall support is for the nat function...

I know that you can use altq to support FreeBSD for bandwidth management.
http://www.csl.sony.co.jp/person/kjc/programs.html#ALTQ

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/