Ingress
Hi all,
I am trying out the example script "Edge31-ca-u32" which configures both
ingress(eth0 for my case) and egress(eth1 for my case) interface on a single linux machine.
For the ingress side, the example uses ingress qdisc. But when i try to
run the very first line "tc qdisc add dev eth0 handle ffff: ingress", I got "RTNETLINK ANSWER: Invalid argument". What is wrong here?
For the ingress interface, can we use other qdisc beside ingress? I tried
installing dsmark in ingress to replace ingress, and i can run the whole script without problem. But when i do "ifconfig", i saw eth0 RX:5402, TX:1 ; eth1 RX:1, TX:5402.
Any suggestions is welcomed. Thanks.
_________________________________________________________________________
Get Your Private, Free E-mail from MSN Hotmail at http://www.hotmail.com.
_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/
Hi,
I was not able to install ingress qdisc as below
tc qdisc add dev eth0 handle ffff: ingress
also tried tc qdisc add dev eth0 ingress
Both cases it says invalid argument.
What could be the problem ?
Andreas
---------------------------------
With Yahoo! Mail you can get a bigger mailbox -- choose a size that fits your needs
Quoted 11 lines · Andreas Wright
Hi,
I was not able to install ingress qdisc as below
tc qdisc add dev eth0 handle ffff: ingress
also tried tc qdisc add dev eth0 ingress
Both cases it says invalid argument.
What could be the problem ?
Have you ingress support in the kernel?
Stef
Signature · 8 lines
[email protected] "Using Linux as bandwidth manager" http://www.docum.org/ #lartc @ irc.oftc.net _______________________________________________ LARTC mailing list / [email protected] http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://lartc.org/