Skip to contentSkip to conversation

Removing a filter/qdisc from an interface

LARTC [email protected] 2 participants 2 messages Jun 5, 2001 – Jun 6, 2001

lore
Share & tools
lore
#0 lore raw

I successfully used a bounded cbq to cut down outgoing bandwidth to certain addresses on eth0:

# tc qdisc add dev eth0 root handle 10: cbq bandwidth 100Mbit avpkt 1000
# tc class add dev eth0 parent 10:0 classid 10:1 cvq bandiwdth 100Mbit
rate 100Mbit allot 1514 weight 1Mbit prio 8 maxburst 20 avpkt 1000
# tc class add dev eth0 parent 10:1 classid 10:100 cbq bandwidth 100Mbit
rate 1Mbit allot 1514 weight 10Kbit prio 1 maxburst 20 avpkt 1000
bounded
# tc qdisc add dev eth0 parent 10:100 sfq quantum 1514b perturb 15
# tc filter add dev eth0 parent 10:0 protocol ip prio 100 u32 match ip
dst 192.168.1.0/24 flowid 10:100

I basically copied this straight out of a howto - now I can't figure out how to remove the limitations (without rebooting that is). I was expecting something like:

# tc filter del 10:100

or possibly

# tc class del 10:100

but clearly I don't really understand what's going on here... any pointers?

Thanks,
Ben

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/

#1 lore raw
Quoted 19 lines · [email protected] wrote:

I successfully used a bounded cbq to cut down outgoing bandwidth to certain addresses on eth0:

# tc qdisc add dev eth0 root handle 10: cbq bandwidth 100Mbit avpkt 1000
# tc class add dev eth0 parent 10:0 classid 10:1 cvq bandiwdth 100Mbit
rate 100Mbit allot 1514 weight 1Mbit prio 8 maxburst 20 avpkt 1000
# tc class add dev eth0 parent 10:1 classid 10:100 cbq bandwidth 100Mbit
rate 1Mbit allot 1514 weight 10Kbit prio 1 maxburst 20 avpkt 1000
bounded
# tc qdisc add dev eth0 parent 10:100 sfq quantum 1514b perturb 15
# tc filter add dev eth0 parent 10:0 protocol ip prio 100 u32 match ip
dst 192.168.1.0/24 flowid 10:100

I basically copied this straight out of a howto - now I can't figure out how to remove the limitations (without rebooting that is). I was expecting something like:

Quoted 8 lines
# tc filter del 10:100

or possibly

# tc class del 10:100

but clearly I don't really understand what's going on here... any pointers?

I'm also just starting with traffic control stuff - so I might be wrong
- but try:

# tc qdisc del dev eth0 root

Juri

_______________________________________________
LARTC mailing list / [email protected]
http://mailman.ds9a.nl/mailman/listinfo/lartc HOWTO: http://ds9a.nl/2.4Routing/