D-Link 660TX with tulip - but no eth0

Hello hotpluggers,

after I properly set up my kernel 2.4.9 to use hotplugging and pccard to get my networkcard running the hotplug-script loads successful the tulip_cb - module without any error.
PCI enables the device 15:00.0 (0000 -} 0003) and lsmod shows that tulip_cb is loaded. But ifconfig eth0 up fails because no eth0 exists. What should I do to get an eth0-device from the tulib_cb - Module?

thanks for Your hints!

bye Leo

_______________________________________________
Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net
[email protected]
http://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel

The hotplug script should not load tulip_cb because tulip_cb is an old-style CardBus driver and is "owned" by cardmgr; the correct hotplug driver would be the plain tulip module.

-- Dave

_______________________________________________
Linux-hotplug-devel mailing list http://linux-hotplug.sourceforge.net
[email protected]
http://lists.sourceforge.net/lists/listinfo/linux-hotplug-devel