SoftSur Problem
Hi,
I have compiled the kernel source code ( from kernel.org ) with the cross compiler ( source code from cygnus). I booted the SoftSur System with the new build of kernel. Since the softsur comes with QL1280 scsi card , i boot through that device after copying the kernel into the proper directory. What i am getting is a SCSI timeout in Qlogic driver when my kernel boots up. If i try with the default kernel it works fine.
Is there any special flag that i need to set when i do a 'make config' during kernel compilation?
TIA
Venkatesh
This normally happens when the IRQ routing information isn't correct for some reason. Perhaps you didn't turn on option CONFIG_IA64_IRQ_ACPI?
--david
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line
Quoted 1 line · Venkatesh Ramamurthy
Venkatesh> Hi, I have compiled the kernel source code ( from Venkatesh> kernel.org ) with the cross compiler ( source code from Venkatesh> cygnus). I booted the SoftSur System with the new build Venkatesh> of kernel. Since the softsur comes with QL1280 scsi card Venkatesh> , i boot through that device after copying the kernel Venkatesh> into the proper directory. What i am getting is a SCSI Venkatesh> timeout in Qlogic driver when my kernel boots up. If i Venkatesh> try with the default kernel it works fine.
Venkatesh> Is there any special flag that i need to set when i do a Venkatesh> 'make config' during kernel compilation?