Skip to contentSkip to conversation

Vibra 16V PnP <-> SuSE 5.3 ?

DISCUSSION Rico Dreier 2 participants 2 messages Mar 12, 1999 – Mar 13, 1999 Sound

lore
Share & tools
lore
#0 lore raw

Hello,

I'm trying to activate a Vibra 16C PnP under SuSE 5.3. Independent of the selected Interrupt 5 or 7 an error occurs during the boot process saying that the interrupt test failed (no other devices use INT5/7 -> /proc/interrupts). The soundcard can not be configured by using YaST since it is not possible to reach the respective menu entry.

The kernel is compiled with audio support etc. selected, but I'm not sure if all the sound options are set correctly :-/ Does the card only work by using the isapnp tool, and does anybody have a valid isapnp.conf file for SoundBlaster Vibra 16C or 16X?

Inserting the sound module with insmod or modprobe leads to unresolved symbols.

Thanks for every hint,
Bye, Rico

#1 lore raw
Quoted 1 line · Rico Dreier

Hello,

moin Rico,

Quoted 5 lines

I'm trying to activate a Vibra 16C PnP under SuSE 5.3. Independent of the selected Interrupt 5 or 7 an error occurs during the boot process saying that the interrupt test failed (no other devices use INT5/7 -> /proc/interrupts). The soundcard can not be configured by using YaST since it is not possible to reach the respective menu entry.

I had this same prob with a soundblaster under SuSE, RedHat and Slackware (I switched from Slackware to SuSE and played with RedHat just to try it out). The problem was BIOS was locking it out. I changed IRQ 5 to be available for isapnp and it was immediately taken by my scsi card and video card, so I loaded the soundcard at IRQ 11 :).

Quoted 6 lines

The kernel is compiled with audio support etc. selected, but I'm not sure if all the sound options are set correctly :-/ Does the card only work by using the isapnp tool, and does anybody have a valid isapnp.conf file for SoundBlaster Vibra 16C or 16X?

Inserting the sound module with insmod or modprobe leads to unresolved symbols.

Same prob I had. This was under 2.0.3x, 2.1.x and 2.2.x. Once I changed the bios AND went to a higher irq it worked. Just moving to a higher irq before hadn't worked...

ciao,

der.hans

Quoted 2 lines

Thanks for every hint,
Bye, Rico

# +++++++++++=================+++++++++++ #

#                   [email protected]                      #
#            http://home.pages.de/~lufthans/              #
#             I've got a photographic memory,             #
#         but I'm lousy photographer. - der.hans          #

# ======+++++++++++++++++++++++++++++++++====== #