Skip to contentSkip to conversation

3D Soundpro PCI

DISCUSSION Eduardo Trettel 2 participants 4 messages Apr 26, 1999 Sound

lore
Share & tools
lore
#0 lore raw

Hi:
Has someone managed to get the "3D SoundPro PCI" card (based
on the CMI-8338 chipset) that comes with some motherboards to work?

Thanks in advance, Trettel

======================================
E. Trettel <[email protected]>
Network Manager

Depto. de Telematica - FEEC - UNICAMP
Bloco B - LB 16
Fone: (019) 788-3849
Campinas - SP - Brasil
======================================

#1 lore raw
Quoted 3 lines · Eduardo Trettel

Hi:
Has someone managed to get the "3D SoundPro PCI" card (based
on the CMI-8338 chipset) that comes with some motherboards to work?

Try /usr/src/linux/Documentation/sound/CMI8330 (with the 2.2 kernel)

Signature · 2 lines
.sig under deconstruction. Please watch out for falling stars.
          http://www.albatross.co.nz/~psycho/        O-
#2 lore raw
In reply to Eduardo Trettel
Quoted 9 lines · Keith Duthie
Quoted 3 lines · Eduardo Trettel

Hi:
Has someone managed to get the "3D SoundPro PCI" card (based
on the CMI-8338 chipset) that comes with some motherboards to work?

Try /usr/src/linux/Documentation/sound/CMI8330 (with the 2.2 kernel)

I've already read this doc, but it describes the ISA version of the board, which is much easier to configure, as long as the I/0 addresses are the same of the SB16. I'm not sure how to handle this on the PCI version. Any hints will be welcomed.

Thanks Trettel

======================================
E. Trettel <[email protected]>
Network Manager

Depto. de Telematica - FEEC - UNICAMP
Bloco B - LB 16
Fone: (019) 788-3849
Campinas - SP - Brasil
======================================

#3 lore raw
In reply to Eduardo Trettel
Quoted 4 lines · Eduardo Trettel

I've already read this doc, but it describes the ISA version of the board, which is much easier to configure, as long as the I/0 addresses are the same of the SB16. I'm not sure how to handle this on the PCI version. Any hints will be welcomed.

Isn't this set up by the pci subsystem? If so, then try looking at /proc/pci to get the io port and interrupt. If not, it may not actually *be* pci.

Note: you could try assigning an interrupt to it in bios

( If the kernel driver doesn't work, you could try alsa at
http://www.alsa-project.org )

Signature · 2 lines
Understanding is a three edged sword. Do you *want* to get the point?
         http://www.albatross.co.nz/~psycho/        O-