Skip to contentSkip to conversation

Linux 2.4.23-pre8

DISCUSSION chas williams 2 participants 2 messages Oct 30, 2003 1 message not in the archive

lore
Share & tools
lore
#1 lore raw
In reply to a message not in the archive
Quoted 12 lines

Well, ATM dosen't work for me. (from 2.4.22, 2.4.21 is OK). No traffic via ATM interfeces.

[root@voices root]# ifconfig atm1
atm1 Link encap:UNSPEC HWaddr 00-00-00-00-00-00-00-00-00-00-00-00-00-00-
00-00
inet addr:XXX.XX.XX.XXX Mask:255.255.255.252 UP RUNNING MTU:9180 Metric:1
RX packets:9 errors:0 dropped:0 overruns:0 frame:0 TX packets:1 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:100
RX bytes:632 (632.0 b) TX bytes:100 (100.0 b)

this doesnt look bad. i see 1 tx packet and some rx packets. how did you test this interface? does tcpdump show anything? could you be more specific about this configuration so i could try to duplicate your setup? the nicstar driver seems to work for me in the 2.4.23-pre8 kernel (ilmid, signalling). i tested the clip module as well but that was via an arp server not clip over a pvc.

Quoted 1 line

Counters on all atm interfeces are still the same

what does atmdiag show?

Quoted 7 lines

On good working kernel, during boot, i have messages like this:

atm_connect (TX: cl 1,bw 0-0,sdu 9188; RX: cl 1,bw 0-0,sdu 9188,AAL 5) atm_connect (TX: cl 1,bw 0-0,sdu 9188; RX: cl 1,bw 0-0,sdu 9188,AAL 5) atm_connect (TX: cl 1,bw 0-0,sdu 9188; RX: cl 1,bw 0-0,sdu 9188,AAL 5) atm_connect (TX: cl 1,bw 0-0,sdu 9188; RX: cl 1,bw 0-0,sdu 9188,AAL 5) atm_connect (TX: cl 1,bw 0-0,sdu 9188; RX: cl 1,bw 0-0,sdu 9188,AAL 5)

these message were eliminated since they arent very useful and quite noisy.

#2 lore raw
Quoted 6 lines · chas williams

this doesnt look bad. i see 1 tx packet and some rx packets. how did you test this interface? does tcpdump show anything? could you be more specific about this configuration so i could try to duplicate your setup? the nicstar driver seems to work for me in the 2.4.23-pre8 kernel (ilmid, signalling). i tested the clip module as well but that was via an arp server not clip over a pvc.

I'm sorry, ATM works on 2.4.23-pre8. I have disabled ipv6 in kernel config. ipv6 was connected with zebra config, zebra was connected with routing. Anyway, it's works, sorry for false alarm.

Signature · 2 lines
*[ Łukasz Trąbiński ]*
SysAdmin @wsisiz.edu.pl