ahci_softreset implementation
Hello,
Recently I have bought mainboard with AMD/ATI 690 + SB600.
2 Seagate 250GB SATA drives are connected. They work with Linux with AHCI without any problem, I have RAID1 on them.
I've been trying to install Solaris on them, however when 2 drives are connected one is not visible to OS.
Could you look at Solaris code and tell if I should fill them a bug-report?
ahci_port_reset:
/* PxTFD.STS.BSY is supposed to be set */
2900 port_task_file = ddi_get32(ahci_ctlp->ahcictl_ahci_acc_handle,
2901 (uint32_t *)AHCI_PORT_PxTFD(ahci_ctlp, port));
2902 if (!(port_task_file & AHCI_TFD_STS_BSY)) {
-> 2903 cmn_err(CE_WARN, "ahci_port_reset: port %d BSY bit "
2904 "is not set after COMINIT signal is received", port);
2905 ahci_portp->ahciport_port_state |= SATA_PSTATE_FAILED;
-> 2906 rval = AHCI_FAILURE;
2907 goto out;
2908 }Linux ahci.c::ahci_softreset also has this check, but works.
Regards,
Jakub
Signature · 1 line
Using Opera's revolutionary e-mail client: http://www.opera.com/mail/
Quoted 8 lines · On Thu, 04 Oct 2007 20:39:52 +0200 Jakub W. Jóźwicki <[email protected]> wrote:
Hello,
Recently I have bought mainboard with AMD/ATI 690 + SB600.
2 Seagate 250GB SATA drives are connected. They work with Linux with AHCI without any problem, I have RAID1 on them.
I've been trying to install Solaris on them, however when 2 drives are connected one is not visible to OS.
Could you look at Solaris code and tell if I should fill them a bug-report?
If you are running Solaris and it doesn't work then yes I would file a bug report - and mention the Linux one does as that'll help them work out whats up.
Alan
--
My Git tree is full of regressions
My Git tree is full of bad C
My Git tree is full of regressions
Oh Git-clone my codebase and see